- Joined
- Jan 21, 2013
- Posts
- 2,267
- Likes
- 264
fleasbaby Nice mods. The wood buttons look much better than the stiff felt ones I've on right now.
fleasbaby Nice mods. The wood buttons look much better than the stiff felt ones I've on right now.
Thanks...and I only almost took the tips off two of my fingers about three times on the sander while making them
Hey there Grado modders, does anyone have a spare headband assembly they wouldn't mind passing on? I'm in need of one for the latest SennGrado build! Shoot me a PM if you can help a brother out!
Oh man...tricky...you looking for a proper Grado headband assembly, or will an Auvio or Sony do it?
I know wje has some SR80 going in the FS forums, those would be your cheapest bet right now...
http://www.bengkelmacro.com/wp-content/uploads/2014/10/e19_DSC8913.jpg
My Grado SR60i, with pptfe housing. Inner and outter diameters just following the stock housing.
I added a removable system to my new 225e wood mod...
I used a wood drill thru so i could fit the female jack...
than I bored the wood with a drill with a larger tip, very very very carefully to not go to deep. so the male jack can fit, as the wood was too thick...
I never solder the original cables out of the drivers, cut just where needed so it can reach the female jack, i also added heat shrink to make a little neater, even tho you can't see the inside that well I know its there...
I also twisted each color cable together so it looks neater as well, again not a biggy, but as you look thru the mesh its more professional i guess...
If you are not that comfortable removing the shield of thin cables make it a little longer to account for errors.