Hello everybody (first of all sorry for my english
).
Just got mine from local dealer and begun experiencing problems from first using.
So previously I used Dr.Dac2 Dx with WireWorld ultraviolet USB cable and was pretty satisfied with headphones output (headphones ATH1000) with OPA627 but not a big pleasure with H-Fi system CA Azur 640A v2 + MA Silver.
So I put X-Sabre to PC (win7) connected with WW USB cable, turned on and installed drivers from USB flash from the box.
After that the system detected X-Sabre and I defined that as a primary audio device in control panel setup.
In working mode Led lights (LOCK, PCM, 44.1Khz) are lighting. When I launched Media Pleayer with avi film x-sabre begun to “clocking” every 30-40 sec (especially when some intensive sound in film occurs) and sound disappears, after that immediately LOCK is lighting, then PCM lighting, then 44.1 KHZ and sound occurs again.. then the same story.
I also made Foobar ASIO/DSD setup and the system with 30-40 sec writing something like: couldn’t write to ASIO buffer
I paid 1.1 k$ so I still believe that some setups missed.
Please advise me.