Grado modders go Magnum

[Capt. Z]

Question to anyone who has purchased Rhoulpat cups with 3 pin mini xlr headphone connector. I just got mine in the mail. I have all my supplies ready to put the drivers in. Which cable coming from the headphone connector should I solder to the red and which should I solder to the white on the driver? Does it matter? I ask because one of the cables on the cups has a not tied in it and the other doesn't and I'm thinking that is trying to tell me the answer but I can't tell if it is meaning solder the knotted one to the red or to the non-red connector. The drivers are the Elleven Acoustica Epsilon G1 if that matters.

I messaged Rhoulpat asking as well but I figured someone on here might have experience with them as well.

Photo attached.

You could use a Voltmeter to see which pin on your connection is + and - ; and then wire it accordingly to that

 

[Patswalker]

You could use a Voltmeter to see which pin on your connection is + and - ; and then wire it accordingly to that

How would I do that? I can go borrow my neighbors later today. I've used them on amps but not on headphone connections like this.

And thank you!