I started diying a senngrado.
Using px100ii drivers.
I used a desoldering pump in order to remove the stock wires.
Problem!
The pump sucked the super thin layer of metal on the solder point...
And one dead driver for esteboune!
Morever I tested the other driver.
Using the multimeter I got a continuity on the - and + solder point...
I don't understand!
Anyway, need to buy a pair of px100ii!
One question: what should be a good iron temperature for this task.
Mine is 60w and can go up to 415'c.
Hopefully, I will be able to post my senngrado here sooner or later!
I'm thinking one of the smaller pads just might share a connection with the larger pad that has the problem. Check that out.