[MrWalkman]

its on 3.02 says mr walkman does stock revert still say mr walkman?

"Stock revert" is an installation package that will make it not show "Mr. Walkman" anymore.

You need to run the corresponding one according to what firmware you have installed right now. I have provided info above.

 

[leo5111]

firmware bar on device only went a little then continued booting pc says the walkman firmware has been initiated?

 

[MrWalkman]

firmware bar on device only went a little then continued booting pc says the walkman firmware has been initiated?

Please read the info I shared above before trying anything else.

 

[nc8000]

firmware bar on device only went a little then continued booting pc says the walkman firmware has been initiated?

It is quite simple if you just follow the instructions that come with the fw you have installed

 

[leo5111]

i did its on 3.02 says model dmp-z1 software 3.02 then says dmpfe classic below thats firmware mod by mr walkman

 

[nc8000]

i did its on 3.02 says model dmp-z1 software 3.02 then says dmpfe classic below thats firmware mod by mr walkman

Yes so you have to do the 2 step revert operation in the instructions I posted to go back to stock and from there you can then install WalkmanOne which again is a 2 step installation plus perhaps editing the settings file

 

[leo5111]

it was fe v2 now its stock 3.02 it didnt say v2 in the about screen before

 

[nc8000]

it was fe v2 now its stock 3.02 it didnt say v2 in the about screen before

Have you done the 2 steps in the revert instructions ?

 

[leo5111]

ok i installed wm1 external tunings then in cfw i set to 1 for warm rebooted player says not applied? its on the mr walkman now

 

[leo5111]

ok got it tuning and all applied thanks for the help guys

 

[nc8000]

ok i installed wm1 external tunings then in cfw i set to 1 for warm rebooted player says not applied? its on the mr walkman now

Are you installing the WalkmanOne fw ?
If so you must first install the base fw which reboots the player, then edit the settings file for the tuning you want, then reboot the player so it reads the new settings and finally install the tuning you want which again reboots the player

 

[leo5111]

i have it all set now thanks

 

[nc8000]

ok got it tuning and all applied thanks for the help guys

Great. This is what mine looks like with the Bright tuning installed

 

[leo5111]

heres mine now

 

[MrWalkman]

heres mine now

Awesome!

What do you think in comparison to DMP-WM1 FE?