You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Hugo TT 2 by Chord Electronics - The Official Thread
- Thread starter ChordElectronics
- Start date
Triode User
Member of the Trade: WAVE High Fidelity
The UK seller should omit UK VAT from the selling price and you should pay your own country VAT upon import so you ought to be paying more or less the same as before. It works the same when we in the UK buy from the EU (or indeed from any other country). I’m not quite sure where you got the figure for the 40% extra taxes.Too bad UK is not in EU. I have to find another brand. I am not gonna pay 40% extra for taxes
After Brex it = forget it
Farad seems to be euro so its fine. What configuration do TT2 users chose?
https://www.faradpowersupplies.com/?sfid=611&_sft_pa_ac-voltage=230&_sft_pa_dc-output=15
Farad seems to be euro so its fine. What configuration do TT2 users chose?
https://www.faradpowersupplies.com/?sfid=611&_sft_pa_ac-voltage=230&_sft_pa_dc-output=15
Just one thing I don´t understand about the TT2. Why did they make 2 SE jacks?
Any reason for this?
Any reason for this?
3 SE jacks.
So you can run more than one headphone.
Say you and a partner wanted too share or watching a film.
So you can run more than one headphone.
Say you and a partner wanted too share or watching a film.
Ok say I wanted to A/B test Arya vs Susvara`?
But thats a lot of power needed for those headphones right?
But thats a lot of power needed for those headphones right?
I read alot of Farad3 users for the TT2 but the Farad only has 3A, and the stock PSU from Chord has 4A.
Last edited:
Do you know if it is possible to get them i EU?The UK seller should omit UK VAT from the selling price and you should pay your own country VAT upon import so you ought to be paying more or less the same as before. It works the same when we in the UK buy from the EU (or indeed from any other country). I’m not quite sure where you got the figure for the 40% extra taxes.
EDIT: Standard Shippin 59pounds??????? Are they out of there got damn mind????
Last edited:
LCMusicLover
Headphoneus Supremus
mScaler ==> TT2 ==> DSHA-3F hereHas anyone had success pairring the TT2 with a good headphone amp?
Ferrum
Enleum
Flux
Niimbus
iFi
Double-plus good
Also nice feeding amp section of Audio-gd Master 11.
Last edited:
Pairs excellently in DAC only mode with Linear Tube Audio MZ3, Schiit Folkvangr and Eddie Current Studio B head amps. The above tube amps round out the very clean detailed sound of the TT2 into a “best of both worlds” combination of high detail, sense of the space and musicality (=long listening sessions). Related, Qutest was a nice pairing with Flux FA-22 but sold the Flux before the TT2 arrived.Has anyone had success pairring the TT2 with a good headphone amp?
Ferrum
Enleum
Flux
Niimbus
iFi
Last edited:
Thanl you very much. Any Solid State amps that comes to mind?Pairs excellently in DAC only mode with Linear Tube Audio MZ3, Schiit Folkvangr and Eddie Current Studio B head amps. The above tube amps round out the very clean detailed sound of the TT2 into a “best of both worlds” combination of high detail, sense of the space and musicality (=long listening sessions). Related, Qutest was a nice pairing with Flux FA-22 but sold the Flux before the TT2 arrived.
That MZ3 does look sweet. How about soundstage, bigger or smaller?
-Is the volume knob to clicky/loud?
- I like products like this that do emphasize on psu also.
you think it will be powerful enough for susvara?
From official site(review)
"I use it mainly as a preamp combined with the Pass XA25 to drive my Susvara/Abyss TC"
Last edited:
MZ3 is only 1W speaker/pre/head amp so not enough power alone for Susvara unless you listen at low volumes. Sound stage matches the recording setting. Big room and it will reveal it. But it will also give you intimate sense of space if the recording environment was such. I like clicky volume knobs but not too loud but certainly noticeable. For pure SS needs, I just use TT2 as is. If you can find a used Flux FA-10 that pushes 16W into 32ohms and may be a good inexpensive option.Thanl you very much. Any Solid State amps that comes to mind?
That MZ3 does look sweet. How about soundstage, bigger or smaller?
-Is the volume knob to clicky/loud?
- I like products like this that do emphasize on psu also.
you think it will be powerful enough for susvara?
From official site(review)
"I use it mainly as a preamp combined with the Pass XA25 to drive my Susvara/Abyss TC"
Last edited:
I don’t discount the potential impacts of power supplies in some cases and use an upgraded power supply on my streamer. However, since the TT2 effectively runs off internal super capacitors and the power supply is simply charging the capacitors from which all the actual components run, I’m struggling to understand how an upgraded PS impacts TT2 sound? Others swear by impacts of upgraded PS for the Chord Qutest for example but not the TT2 due to said super capacitors.
I think Rob Watts had previously posted his opinions on adding a LPS to the TT2 . They do change the sound, albeit not necessarily in a positive manner:
https://www.head-fi.org/threads/hug...official-thread.879425/page-653#post-15718333
Nothing against those who choose to add an lps though. This is a subjective hobby after all.
I sometimes run the TT2 through the ALO Studio Six. You lose a bit of fine detail in exchange for a bit more of a "euphonic" sound. I only have two pairs of headphones that actually require a better headphone amplifier, and one is unobtainable now (LCD-R).Has anyone had success pairring the TT2 with a good headphone amp?
I've tried capacitor banks and noise filters on the TT2 with no change in the sound, so unless a different PSU is adding noise, I can't see why one would make a difference. More details about what is "better" with one added would be interesting though.
Last edited:
801evan
Headphoneus Supremus
If you're clipping your susvara in the tt2 and can't hear the difference in psu change on the tt2...clearly a issue in your chain setup. Tt2 psu change is very apparent.I sometimes run the TT2 through the ALO Studio Six. You lose a bit of fine detail in exchange for a bit more of a "euphonic" sound. I only have two pairs of headphones that actually require a better headphone amplifier, and one is unobtainable now (LCD-R).
I've tried capacitor banks and noise filters on the TT2 with no change in the sound, so unless a different PSU is adding noise, I can't see why one would make a difference. More details about what is "better" with one added would be interesting though.
Users who are viewing this thread
Total: 20 (members: 0, guests: 20)