Just updated my R6 after watching the video.
It was very easy and all went flawlessly.
After the update you can remove the driver from your system.
I noticed that the driver installation had put Windows 10 in testmode (to be able to install the unsigned driver).
(screenprint is not from my system)
Maybe someone else already mentioned this but if not:
You can switch windows back to "Normal" mode by opening a CMD box as an Administrator
- Click Start
- Type CMD
- You see the Command Prompt appear
- Rightclick on it and choose "Run as Administrator".
- Enter the following commands :
1> bcdedit.exe -set loadoptions ENABLE_INTEGRITY_CHECKS
2> bcdedit.exe -set TESTSIGNING OFF
- Reboot your system.
- All is fine again.
This also works for Windows 7 and Windows 8.
By the way, I noticed I had less free space after the update.
Ofcourse this was to be expected after an update to an OS 2 major releases higher and the repartitioning.
I think they did a great job slimming it down. No fluff at all! Just the minimum on applications.