I was going to make you guys wait...but...without further adieu....
LFF’s Paradox Suspension Headband Mod For Your T50RP
PROJECT TIME:
Under 10 minutes
MATERIALS NEEDED:
1 Brand new Coke can with soda inside (sealed). Chilled preferably.
1 Hole Punch
1 sheet of paper
2 rubber hair ties
2 hands (yours preferably)
Step One:
Grab your chilled Coke and set it aside so that you only have the following materials left:
Step Two:
Take that sheet of paper and fold it in half:
Step Three:
Fold it in half again.
Step Four:
Fold it in half length wise....show it who's boss...
Step Five:
Grab your paper and punch a hole in on the side....try to center it...
Step Six:
Turn it around and punch a hole on the other side.
Step Seven:
Grab a rubber hair tie and place it through the hole.
Step Eight:
Put one end of the hair tie through the other end so it loops and secures itself on the paper.
Step Nine:
Repeat step eight on the other side.
Step Ten:
Grab one end of the hair tie on one side and pass it through the metal bars of your T50RP and secure it by looping over the rounded top part of the metal bars.
Step Eleven:
Repeat on other side.
See above pictures...
Step Twelve:
Congratulations! You have now created a suspension headband that is super cheap and comfy!
Step Thirteen:
Skip this…it’s bad luck.
Step Fourteen:
Grad your chilled Coke can, open it and enjoy it while listening to music on your super comfy T50RP.
NOTES: I would recommend you use a nice piece of leather or cloth instead of the paper. The paper was mostly for a quick demonstration and so you know what size of leather/cloth you will need for this.
Enjoy!