gefski
1000+ Head-Fier
Yes, clearly it won't fit. Is that a standard 6de7/6fd7 size tube on the right? Here's my top plate with Sylvania 6de7 tubes--lots of room.
Thanks for the info. Guess you could try it without the plate, huh?
So the pins on yours don't go all the way down into the sockets? Looks great, by the way.
Here's a pic from the Woo site; this is the 6em7 adaptor, which looks to have adequate room.
Thank you,
The black rings in the middle of (2-peice) adapters which cover the seams of the adapters do not allow the adapters to pass below the bezel's, but still make more than enough contact with the sockets, so no, the adapters are not fully seated against the sockets , but are seated more than enough that I've never had any issues.
The Woo photo sure looks like it has enough room for the adapters to be fully seated against the sockets…which is how my was before putting the wood/bezel's on…the adapters were fully seated, which is why I don't understand Poteroso's issue with the amp/adapters?
Right, so you, with most others, have the newer version of the amp. In case words were not enough here is a picture. I find that pictures often satisfy when what I say does not.
Instead of reaching for the skies even more remove the plate ,go to a machine shop they will widen those holes no problem would be much nicer then extenders .Just make shure and tell them what its for and you dont want no scrathes
I will probably end up doing this, but I am in school for mechanical engineering, and at some point I imagine I will be able to do this myself in the shop. For now, I'll just use the extenders, though I'll end up with an extender, then 2 adapters, in between the tubes and the amp... Not cool. Extender, to 6SN7 adapter, to 6F8G adapter. Will look messy, should be fine though.
I have a good suggestion for you…I would think that the chassis on your WA6 is the same as the newer WA6 so why don't you contact Jack at Woo and ask him if it is, and if it is, ask him to send you a newer style top plate with the larger diameter holes so you don't need all of the adapters and they'll fit right into the sockets…how much could he possibly charge you for the top plate? Just a suggestion.
He wouldn't sell me just the plate when I asked about a year ago.
If it is a simple retro fit then that is not good service from Woo I hope there was more to it that just the ability to just swap plates which stopped the plate supply.
Is it WA6 pair well with HD650/T1 and Dt990 600 ohms ? I am confused between WA6 or Lyr2
Is it WA6 pair well with HD650/T1 and Dt990 600 ohms ? I am confused between WA6 or Lyr2