It all depends on where the LED is wired into the circuit. If it's before a cap, it'll probably go out immediately. If it's after a cap, it'll probably linger for a while.
Its an interesting topic of discussion. My WA2 plays music for a solid 10-15 seconds after powering off, but the light turns off immediately. The MJ2 is the same way.
I remember old power amps slowly fading off after powering down.
I am guessing it was a design choice and has more to do with keeping the circuit simple
So I tried driving the headphones after removing power, turned volume up, etc, and it seems to make no difference in how long the white led says on. It’s very slowly dimming like normal. It’s been over 15 minutes now and I’m guessing there’s another 15 or 20 to go before it is out.
And yes, the high voltage caps in an amp can and do hold their charge for a long time. At Sonos in the hardware lab where I work, we have special discharge boxes to discharge these capacitors. AMP and SUB have 400V rails and a fair amount of capacitance. You do not want to get zapped by one of those caps! I’ve not yet had that happen but one of the other engineers has and let’s just say it isn’t fun.
So I installed the adapters and my CV455’s and spent an hour or two listening and . . . is it possible I got really REALLY lucky with my stock tubes?
Or do I need to wait like 10 hours more before the CV455’s hit their stride?
Or is it possible I got unlucky with my CV455’s?
Because . . . so far, I think I prefer the stock tubes. Sorry if this is insanity!!! LOL!
More like 50 hrs before they really start hitting their stride and even get better after that. But then again we all have different ears, brains, and preferences. Not to mention the type of music you like to listen to and the rest of your system.
If after 50 hours you still feel the same, you can turn your audiophile card in at the exit.
Seriously -- give it 50 hours. Preferences and synergy play a big part. Plus, if the stock tubes were that horrible, I don't think Schiit would include them.
So one of my CV4033’s has a crackle / poor connection sound. I cleaned the pins with an eraser and 91 percent iso and reseated, but no joy. I also cleaned the adapters but I know it’s not them as the CV455’s were perfect.
Any suggestions?
Also, re: cleaning, I found the Tombow Mono Zero eraser pen/stylus to be the perfect tool for cleaning tube pins.
Oh, and to remove the adapter that didn’t come out with the tube, I cut two strips of blue painters tape and used a plastic spudger tool to adhere the ends to opposite sides of the adapter, then just grabbed each one and lifted and gently rocked back and forth and voila! No metal, no excessive force or pressure on the adapter.
Can anyone recommend a good brand of "pro" audio cables for my Sennheiser 6xx? Since we are all using the Valhalla here, you know I can't use balanced cables so please keep that in mind with your recommendations. I understand there is an element of "snake oil" with a lot of these cables, but I can afford to buy my little bits of peace of mind
Can anyone recommend a good brand of "pro" audio cables for my Sennheiser 6xx? Since we are all using the Valhalla here, you know I can't use balanced cables so please keep that in mind with your recommendations. I understand there is an element of "snake oil" with a lot of these cables, but I can afford to buy my little bits of peace of mind
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.