@ alissa914,
Hello Lauren,
which SDXC-Cards did you use for your 2TB iPod... or did you just use 2 1TB SD-Cards?
Did you then just connect the iPod to the Computer/Laptop and get it formatted?
Greets,
Julia
I had one single 1TB micro SD card (Sandisk).... Whenever I put it in my Quad, the board reports total size as 200GB which is odd. Even if I clear the partition table with DISKPART and CLEAN, it just shows 200GB. If I add any other cards, still 200GB.
Not sure how people are getting this to work but I imagine having 4x 1TB cards is probably why you can. It just seems that the Quad is not capable of dealing with the 1TB card and any other size card with it.... at least not on my board.
Card formats and partitions fine on Windows and Android... haven't had any data overwrites causing corruption yet to where I'd think the card capacity was faked....
It seems to just be the board's problem with the 1TB card to where I wonder if maybe I had an old revision or it's a fixable problem on the hardware side that would be addressed later... maybe I should just leave it as is and put it in my tablet instead of the iPod. Seems that 2TB is my ceiling for the moment w/ my 4x 512GB cards.
And yes, I've done this many many times with micro SD cards so I'm aware of how to put micro SD cards in my iPod and make them work. Unfortunately the iFlash Quad board I had seems to just go off the rails once the 1TB card is in... and everyone keeps telling me random basic troubleshooting steps as if I haven't tried all of those.
The steps are: CLEAN partition table on micro SD cards, plug them into iPod, hook up drive to iPod, restore iPod in iTunes. Drive shows up. That's how it has been for all micro SD cards until I got a 1TB card. And yes, the 1TB card formats by itself just fine on a PC and tablet and I've put over 200GB on the card without incident.