PockyG
100+ Head-Fier
I could be wrong but the set that he/she printed out was an early version of the fazors that had the tip of the fazors printed on the bed which may have caused it to gain more surface area than intended. The later revision I printed out had the tips face up which gave them a rounder finish I think. I made a post with a picture of them earlier:I got a set of the fazor inserts from @SomeTechNoob. I know there was some discussion about that flat surface on the outside of each louver. Has anyone taken the time to round these off for better air flow? If so, was there any discernible difference from doing this? I am just trying to figure out whether it is worth the time that it would take to do it. It did seem from the Audeze diagrams, that this was their intent. Likely just the OCD engineer in me making me wonder.
How do yours compare to these?