VRacer-111
1000+ Head-Fier
I don't know anything about 3D printing. How much does it cost to make a set of these grills? Once you nail down the design, is there a chance you would sell these? They are very cool looking!
Well I'm just getting started with 3D printing, but material costs aren't too bad: spools will normally run $20ish to $50ish and 500g to 1kg depending on material. The silver PLA 1kg spool I'm using to get the hang of this costs about $23, so the two printed pieces I just did would have a total material cost of $1.05....final revision will be less material and printed at maximum quality. I also have a spool of silver ABS (1kg spool for $30) and PLA Woodfill material (600g spool for $36). I really don't want to get into a business at this point but would be more than willing to work with any forum member if they want a custom design would just want compensation for shipping costs. Want to keep this a hobby. I will put up the final 3D model when done so anyone can print it out or have it printed by an online printing site.
Last edited: