cuiter23
Headphoneus Supremus
Same, mine should be done sometime next week.
Sick! Looking forward to your impressions
Same, mine should be done sometime next week.
I've written a comparative review of the full Olympus line up a couple months ago, if you are interested, it is on page 116 of this tread.Sick! Looking forward to your impressions
I've written a comparative review of the full Olympus line up a couple months ago, if you are interested, it is on page 116 of this tread.
I'd like to preface the procedure by adding "DO IT AT YOUR OWN RISK"
What you need:
- A really sharp knife/blade
- A wire cutter
- Duct tape
How to do it:
- Best to do the procedure under a table lamp
- Straighten out the wires and lay it flat on a table
- Lay the cable on the surface in a manner that the memory wire and the cable itself are parallel to each other
- make sure the remaining cable is laying on the table as well and not hanging down from the table
- apply 2 small pieces of duct tape. One on the IEM connector and the other at right before where the memory wire starts on the cable
- using the knife, make a smooth slit along the length of the tubing starting from the IEM connector end. Make sure you start a 1/4 inch or few mm from the IEM connector
- also make the slit where the memory wire is right under the tubing and not the cable line
- the memory wire should pop out of the tubing
- use the wire cutter to snif it off
- you can either choose to keep the tubing by applying a single layer of tape over it or cut it off carefully
I'd like to preface the procedure by adding "DO IT AT YOUR OWN RISK"
While I liked the BTG cable... I didn't like the memory wire... I just don't like memory wire at all.
How could I safely remove it... I mean real safe...
You could just ask me. I can remove it for you =)
Men, this is just a bad attitude!! We need to scream and cry till we get what we want! Preferably right now!
You could just ask me. I can remove it for you =)
I just hope the BTG wire doesn't itch or keep the ciems in place
BTW, this is my first custom (and only for the next 5 years) do they stay in place even without wire?
Any suggestions for 3rd party cables for Zeus r? I know the big cable is included but just seeing if there's anything better out there. Tried contacting toxic cables and went on the toxic cables thread but not getting too much feedback. Also waiting for Linum superbax to come out but the two pin version seems to be taking ages