Christoph
100+ Head-Fier
I'm looking for a good braiding tutorial for 8 strands. Does anybody have a link to such a tutorial?
Here you go!I'm looking for a good braiding tutorial for 8 strands. Does anybody have a link to such a tutorial?
I'm looking for a good braiding tutorial for 8 strands. Does anybody have a link to such a tutorial?
I've just done a multimeter test. The standard 3.5mm jacks both have continuity on the tip and sleeve, but none on the rings. Is this the supposed configuration for an unbalanced set-up? Or It's a tip and sleeve only connection for unbalanced/balanced modes?Your image is correct
talking about the TRS 3.5mm cable that comes with it, the two 3.5mm headphone jacks that go into the L and R headphones seem to have redundant rings (no continuity).Are you talking about 3.5 stereo or trrs
talking about the TRS 3.5mm cable that comes with it, the two 3.5mm headphone jacks that go into the L and R headphones seem to have redundant rings (no continuity).
Ok, thanks! I'll give it a go soldering and will report back hereIf it's going into the earcups then that makes sense. You only need one positive and one ground per side.
Ok, thanks! I'll give it a go soldering and will report back here
Yep, just found this diagram which confirms it (I'm sure it's same for the 3.5mm)Just be sure you've got the correct pin-out for whatever headphones you're working on.