-
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.I'm going to make my first balanced headphone cables from scratch, is there a general rule of thumb what length and AWG cable I should...
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.Just a quick update. All soldered and working. Basically converted a 2 pin to a TRS for the headset pin out as the 2-pin was readily...
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.Yep, just found this diagram which confirms it (I'm sure it's same for the 3.5mm) and for the Fiio TRRS connector Wish me luck!
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.Ok, thanks! I'll give it a go soldering and will report back here :)
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.talking about the TRS 3.5mm cable that comes with it, the two 3.5mm headphone jacks that go into the L and R headphones seem to have...
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.I've just done a multimeter test. The standard 3.5mm jacks both have continuity on the tip and sleeve, but none on the rings. Is this...
-
Aarksez replied to the thread DIY Cable Questions and Comments Thread.Just got a pair of sundaras and is in the process of making a 2.5mm balanced cable so I can use it on the Fiio K3. Does it matter which...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…