Wfanning1
100+ Head-Fier
- Joined
- Oct 20, 2013
- Posts
- 194
- Likes
- 26
Can you give us some closer pictures im interested in the detail thanks in advance!I find it in the diy cable question e discussion thread in this section
Can you give us some closer pictures im interested in the detail thanks in advance!I find it in the diy cable question e discussion thread in this section
That's super super awesome! But wouldn't you find that your microusb to lightning is too long for portable use?Here's a picture of a DIY cable with a difference.
I recabled some RHA 750s after breaking the original cable,but rather than run a full length cable I made a super short version. This allows me to connect a small DAC or bluetooth receiver mic controller at the junction point. The picture shows my Fiio K1 connected, the micro USB cable plugs straight into my iPhone's lightning socket. The K1 has a detachable clip so I can just clip it to my shirt. The other dongle is the bluetooth mic/receiver.
That's super super awesome! But wouldn't you find that your microusb to lightning is too long for portable use?
Here's a picture of a DIY cable with a difference.
I recabled some RHA 750s after breaking the original cable,but rather than run a full length cable I made a super short version. This allows me to connect a small DAC or bluetooth receiver mic controller at the junction point. The picture shows my Fiio K1 connected, the micro USB cable plugs straight into my iPhone's lightning socket. The K1 has a detachable clip so I can just clip it to my shirt. The other dongle is the bluetooth mic/receiver.
Awesome! I didnt go as far as to recable my RHA MA750is but rather sleeved the lower portion with 3m reflective 550 paracord and replaced the plug with an Amazon TRRS alternative. To retain the RHA plug sleeve (for pure aesthetics) I simply heated it up using a pencil torch and removed the remaining material from the original plug. The sleeve was slightly smaller than the new plug so before soldering I placed tape over the plug, chucked it in the drill, and used a person file to achieve the required diameter. Everything works and looks great now!
Question for you guys.
Where's the best place to get some decent 24-26 awg occ that is flexible and cheap?
Thanks in advance
Does BTG have OCC? They didn't when I was buying. They do have great OFC.