Bump

Bump

Can you guys recommend me a set of detachable cables for my t51i? Also, not sure which connection to use (mmcx, etc). I also have an extra set of Mee pinacle PX mmcx detachable cables, so I could purchase two mmcx female connectors and mount them Frequency Response: 10-23,000 Hz. Sensitivity...

Hey guys, I need your expertise! I've got a pair of non-detachable Vsonic vsd3 that have a connection issue at the base of the ear piece housing.   Making the switch from wired to detachable would be a good investment. I plan to dremmel, then epoxy in a 2 pin socket, and ideally have the...

Is it possible that vsonic separated the ground into left and right? The four wires in the vsd3 cord are L+, R+, L-, and R-? Also, there are blue dots next to one of the two solder joints on each driver. How do i figure out which solder joint is ground and which is l/r +? There's a dark silver...

Another look at the construction of a pair of vsd3 red-blue non-detachable... I used a sharp blade to weaken the sticky glue that held together the two sides of the housing. -didn't actually use the screwdriver since it chipped the housing    the wires are oxidizing and the rubber...

I broke my vsd3 non-detachables around this time last year. I currently own a pair of beyerdynamic t-51i and kz-ed 10. I miss the emphasized treble and tight bass on the vsd3. I would like to purchase the new vsd3s *third gen since my kz-ed 10 are having audio cut-outs at the jack, but...

WHAT THE... haha my pair of vsonic vsd3 are silver plated and i have a small perforation on the top rubber sleeve material on the right line(before y splitter). It's starting to go green. Maybe i should patch that up with some electrical tape, eh?

LMUE said that i could just ship the broken vsd3 in a straight up envelope since they were already broken. I have to pay for shipping fees b/c it's been over 30 days, unfortunately. thought it was nbd 'till i took a look at the shipping cost for something .05 kg... was about ~ 50 USD from the...

LMUE is offering a replacement, but I've got to pay for shipping fees to their office in Singapore. pay for shipping, then install the neutrik jack, or keep the old one and install the neutrik jack? lmao decisions, decisions @Shawn71

New vsonic earphones for this year "New products VSD2, VSD2S are planned to be released on March 18 17:00 on Tianmao. There will be only 2000 sets available with a price of 199 CNY (literally less than 40 USD). With the order, you will get another pair of VSONIC 16th anniversary special...

@Shawn71@DanielKRegoThanks for the replies. Looks like this project is going to take a lot of hard work. I've done soldering projects before, but not on audio components. Another issue I have is the silver shielding before the Y split is gaping, exposing some of the right channel wires? IDK if...

Thinking of DIY this neutrik right Angeled jack for my vsd3.I can sauter, but am unsure of how vsonic color codes the wire... :0 @danielkrego You think jerry would mind if I asked? Lmao http://www.tradeindia.com/Seller-6799457-JERRY-NORONHA-ELECTRONIC-EMPORIUM/#contact

WOW! I have the v-sonic vsd3 I use 4 clicks.

how many clicks volume do you guys listen to music on the opo? (no amp)