My new favorite: DT900 with DT700 earpads!

Yes, I'm aware of that, but my question was how does it affect the sound if I replace the old thicker pleather earpads with the new thinner leather ones? There has to be a difference in sound to some degree and I'm a bit worried that some sub-bass might be lost mainly due to the different...

Yes, I have the first first version of the 2CB where the pads are also pleather, but thicker/deeper than the new ones. But they are starting to fall apart, so I'm thinking of replacing them with new leather ones that aren't as thick as the old ones.

Hi, has anyone replaced the original old thick pleather pads with the new leather ones? I'm a little afraid that 2CB will lose the subbass with the new pads.

Anyone has tried Dekoni Fenestrated Sheepskin earpads with 2CB?

Hey, anybody could compare Model X to Craft Ears SIX? Thanks!

Hey, anybody could compare SIX to Lime Model X? Thanks!

Hi Piotr, when should be these new IEM available? Thanks

  Just tried the H82, and I only set the LO MIX to 1.0 and put the input gain a bit down and that's it, that is exactly what I was looking for!! Thanks a lot :)

Could someone recommend me any amp with the bass knob, please? I think that's exactly what I'm looking for.

I've got Apogee Duet 2 which I quite like so far but actually I think I need something more powerful, mainly to focus on the low end as I want to use LCD2's also for the technical reasons and I would prefer to buy a better amp that will be more powerful and can reveals more details in low end...

Yes I have them for a few days and I quite like the low end they are able to reproduce but I feel I need it just a bit more emphasized and hear all its detail a bit more closely. 

I'm sorry for my incorrect expression, I meant not to blow them to extremes, more likely to emphasize and extend details of the low end and perhaps to just a bit toughen it up.

Hi, I've just read about last 50 posts but I haven't found any amp that could fulfill my requirements. I'm looking for the amp that can strengthen and boost the sub and lower bass spectrum of LCD-2's Rev2. I primarily need to hear what is going on between 40-120Hz as with a magnifying glass...

I'm in as well. I've got the UERMs, so don't know if it is worth to get probably similar C4s so C5s seem to be more interesting for me.

you must try DT990! I had exactly the same problem as you 2 months ago, and DT990 won!

no sense! it should make a sense if you pay 4000$ for extends your ears frequency response in the surgery then pay next 4000$ for the 20 drivers in-ear monitors.   h e a d & s c i - f i . o r g

All you need for music production and sound engineering is FLAT response! >> UERM

Thank you very much for detailed answer So, do you think that K701 is good choice for this audio interface? Do you have any good idea for solve this problem? Any cheaper Amp? THANKS

Thanks for answer,,, I have Sennheiser HD25 for DJing and I need K701 for production and mixing. There are headphone output specifications: Load Impedance16 Ohms – 600 Ohms Maximum Output Level (100 Ohm load)1,55 V RMS (load 100Ohm), 3,1V RMS (no load) SNR (weighted)93 dBu THD+N (100...

thank you for your answer... I don't need drive to their absolutely full potential, but I need headphones with neutral sound to electronic music production and these are winners. I considered also about HD650, but K701 are better for mixing.

there are headphone output specifications: Load Impedance16 Ohms – 600 Ohms Maximum Output Level (100 Ohm load)1,55 V RMS (load 100Ohm), 3,1V RMS (no load) SNR (weighted)93 dBu THD+N (100 Ohms)0,016% Frequency Response +/- 1 dBu10 Hz-40 kHz

Hi, i have NI Audio 8 DJ soundcard and i want to buy a K701 but i'm not sure if amp in this card will be enought for K701. Thank you

Hi, i have NI Audio 8 DJ soundcard and i want to buy a K701 but i'm not sure if amp in this card will be enought for K701. Thank you, and sorry for my bad english