BobSaysHi
Headphoneus Supremus
- Joined
- Jun 28, 2010
- Posts
- 3,370
- Likes
- 96
^ that would be one very, very long video. I think that the pictures plus the written explanation are enough.
bill the pictures are great. thanks. i was wondering if you could try to video tape the whole process next time your "helping out a friend" with their sr60s?
^ that would be one very, very long video. I think that the pictures plus the written explanation are enough.
thanks bill. also would you be willing to pm the full non-edited one because i've never done any diy mods?
Meh. Tried fixing my driver and failed pretty miserably. Apparently I have to get the thing open before I can even attempt at reconnecting the wire, and somehow my driver just refused to come out from its housing. How did any of you pry it out if the plastic is weaker than the glue holding the two pieces together? ><
You have to go medieval on the driver. It's hard to explain, but once you do it, you'll understand. Don't give up yet. You want to pry it up, not to the side. Pry it up with all your strength. I used a hairdryer to keep it warm.
Anything I take to the driver ends up bending the housing rather than prying it up. And didn't he said something about not going hog-wild. I tried the soft approach first, then realized that didn't work and went mad on it, only to have a few deformities on my driver and the realization that that wasn't going to work either.
you have to go in circles before trying to pry it