What’s your source? I’ve had odd buzzing sounds sometimes when I turn the amp on while I’m BT mode but once I switch inputs it goes away. I can’t figure that out. I have Sparkos op amps in the volume stage and Staccato opamps for the input stage and I get more of a “pop” with the staccato op amps. Still my amp is very quiet, thankfully, after my very noisy Woo amp.
Have you taken the RME out of the chain just confirm that the last bit of the buzzing is isolated to the Burson? Could it be your cables? I only ask that as years ago I got an amp that I thought was faulty and it turned out to be a cable which was odd as it had worked fine up until then.
Abyss Diana Phi for headphones. The earbuds are 300Ω and 500Ω so pretty much need the amp. That said I do have some CCA-CRA iems that are quite noisy with the Burson so maybe I just don’t use efficient enough gear to get noise.
Have you taken the RME out of the chain just confirm that the last bit of the buzzing is isolated to the Burson? Could it be your cables? I only ask that as years ago I got an amp that I thought was faulty and it turned out to be a cable which was odd as it had worked fine up until then.
Abyss Diana Phi for headphones. The earbuds are 300Ω and 500Ω so pretty much need the amp. That said I do have some CCA-CRA iems that are quite noisy with the Burson so maybe I just don’t use efficient enough gear to get noise.
Oh yea same issue with everything unplugged and nothing at all hooked up. Probably I’m just using way too sensitive stuff. My IEM’s are all 16Ohm and >105dB/mW… so yea definitely a gear pairing issue I suppose. I barely notice any noise with a RAD-0.
Oh yea same issue with everything unplugged and nothing at all hooked up. Probably I’m just using way too sensitive stuff. My IEM’s are all 16Ohm and >105dB/mW… so yea definitely a gear pairing issue I suppose. I barely notice any noise with a RAD-0.
I can easily connect a USB-A/USB-C cable between the Surface Dock and the Burson Conductor 3XR to reliably connect, but a USB-C/USB-C cable seems to have difficulties. Any suggestions?
I can easily connect a USB-A/USB-C cable between the Surface Dock and the Burson Conductor 3XR to reliably connect, but a USB-C/USB-C cable seems to have difficulties. Any suggestions?
Have you tried USB-C/USB-C OTG cable? If yes, have you connected it to the right direction? (It works only in one way, should be marked on the cable).
If not, it might worth a try.
I can easily connect a USB-A/USB-C cable between the Surface Dock and the Burson Conductor 3XR to reliably connect, but a USB-C/USB-C cable seems to have difficulties. Any suggestions?
When I‘ve been using BT mode and turn on the amp, I get a fair amount of noise. but if I just cycle through the inputs and come back to BT it’s silent again. Just a minor inconvenience but I wondered why this would be.
I forgot to mention that Burson Audio were extremely helpful with my USB-C problems. They were fixed with a new board that I easily inserted myself following instructions. This is a great company.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.