Vitaly2017
Headphoneus Supremus
Things got quiet lately did everyone finish their mods ? How does your new mods sound?
I'am just wait for silver sheet to come in for backplate mod. In the meanwhile, I'm still playing around with tuning OrionV2.Things got quiet lately did everyone finish their mods ? How does your new mods sound?
Silver sheet just came in right now. After preliminary test, bass is heavily and very impactful. More dynamic, soundstage, seperation and holographic. Treble is even more finer too.
Copper plate is a bit less energetic overall.
Did you have it precut?Silver sheet just came in right now. After preliminary test, bass is heavily and very impactful. More dynamic, soundstage, seperation and holographic. Treble is even more finer too.
Copper plate is a bit less energetic overall.
This is just for shielding purpose though.I would of tought copper had those properties....
Silver is more neutral I would of think
Nope. There is no precut. It's 28 gauge. Not that hard to saw or cut. I'm gonna triple layer it maybe even more.Did you have it precut?
I don't think so because it's mainly the output wires.Looking into WM1Z mods. Is the WM1Z + K Mod from Music Sanctuary good enough if I don't want to invest too much time?
Yes, I experienced this Cardas solder being the easiest also.Cardas Ithink is the easiest to work with and doesn't degrade the sound.
Although the mundorf looks & works good, I still believe the Cardas was easier to work with. Very smooth.How good is cardas vs mundorf supreme?
So your using it for the exterior backplate, or for the small internal plate?Silver sheet just came in right now. After preliminary test, bass is heavily and very impactful. More dynamic, soundstage, seperation and holographic. Treble is even more finer too.
Copper plate is a bit less energetic overall.
Cost for the same size/price ratio is up to 35x more expensive for silver vs copper.
I needed to wait for some more 50uf kaisie(replacing the elna silmic choice), as I am going all kaisie.Things got quiet lately did everyone finish their mods ? How does your new mods sound?
Going to be internal plate when finish. Will post some photos when it's all done.I don't think so because it's mainly the output wires.
I will post pics Tuesday, as I will open my 1z which is kmoded.
Yes, I experienced this Cardas solder being the easiest also.
Although the mundorf looks & works good, I still believe the Cardas was easier to work with. Very smooth.
So your using it for the exterior backplate, or for the small internal plate?
I needed to wait for some more 50uf kaisie(replacing the elna silmic choice), as I am going all kaisie.
Just came in yesterday.
Ok this one I never expected to be an issue but our own ears are at the fault we have some bad hearings!!
https://www.flareaudio.com/pages/ca...SE8YSu1Ukyb_osOoiYQUmhtQdqIbwNuSAHA0ifpYkkbJo