error401
1000+ Head-Fier
- Joined
- Oct 11, 2006
- Posts
- 1,244
- Likes
- 11
Just make the knob plain and the legend go to 11. Easy
Originally Posted by ludoo /img/forum/go_quote.gif My build, fully clothed (the volume knob is a Fender original one and it's Kabeer's idea) It really sounds very good. Thanks a lot to Pete and all the people in this thread. |
Originally Posted by MoxMonkey /img/forum/go_quote.gif is there any harm running r3/r9 from the leg of the mosfet and then using wire or should it just be using the resistor leg's when connected? |
Originally Posted by looser101 /img/forum/go_quote.gif r3/r9 should be soldered directly to the leg of the mosfet, preferably. Keep the resistors leg reasonably short as well. You can run a wire from the other side of those resistors if you like. |
Originally Posted by Citizen86 /img/forum/go_quote.gif @error401, So you did you use the case for grounding? |
Originally Posted by error401 /img/forum/go_quote.gif For ground I just used the negative lead of the main power cap as a star ground and soldered wires to it for each ground connection. Gets a bit messy with a huge, hard to melt solder blob, but it works fine. |
Originally Posted by Coreyk78 /img/forum/go_quote.gif Bypassing would be soldering the film cap in parallel with the electrolytic right? |
Originally Posted by gurusan /img/forum/go_quote.gif This is correct right? In parallel? |