my cfa3 is complete and has been shipped and in the hands of
@GoldenOne. he's got it warming up and will be giving some impressions and measurements hopefully eventually.
2-chassis solution, 10mm thick front on both. Black chassis/knob
- TKD 10K quad attenuator
- Matched octet of low noise JFET transistors for input.
- Matched small-signal transistors throughout the build
- Matched Toshiba output transistors
- Golden Reference +/-30V power supply and Elna Silmic capacitors, throughout the build.
- Low noise transformer 150VA, 115VAC
- Headphone Protector/Delay board
- Double shielded OFC wire (for signal)
- 5W non-inductive output resistors
- XLR inputs, 4-pin XLR output jack.
- Power switch on the front of external PSU
- Mains selector switch 115V - 230V
- RCA input/6,35mm jack
- Speaker taps + switch HP/SP