DX220 A new view to your music. *** LATEST FW: 1.19 Local *** Link for User Guide 1st Page.

[yannis]

I have also video have sent to me earlier by Paul. If anyone wanted, I can share as well here, but Edward’s description is just perfect

Please share! Thank you!

 

[nxxo]

I have also video have sent to me earlier by Paul. If anyone wanted, I can share as well here, but Edward’s description is just perfect

Yes i want the video too thx you sir

 

[behemothkat]

I didn’t expect so many requests
I have uploaded original video I got from Paul to YouTube.
Accessible through link only:

 

[Whitigir]

Please use plastic tool to remove battery connector, and not the metal tweezer as the video. Lol...one slip and you will have a nice spark that could ruin both unit or worse

 

[behemothkat]

Please use plastic tool to remove battery connector, and not the metal tweezer as the video. Lol...one slip and you will have a nice spark that could ruin both unit or worse

I hope everyone knows how carefully have to handle Lithium batteries

 

[yannis]

I hope everyone knows how carefully have to handle Lithium batteries

Just wear glows and everything is fine

 

[edwardsean]

Please use plastic tool to remove battery connector, and not the metal tweezer as the video. Lol...one slip and you will have a nice spark that could ruin both unit or worse

Also, if you slip you could scratch the glossy back cover, or poke your hand.

Please keep in mind that the technician in the video is skilled. If you don't have much experience with thing like this, the suction cup is the safer method.

Also, I would recommend leaving the second wire (wifi) connected and just flipping the cover over. You should be fine disconnecting/reconnecting, but the pin is tiny and thin. If you misalign it and try to force it, it could snap off.

 

[iMongui]

Apart of Fidelizer, anyone knows someone who's on this business and is able to mod an amp8? Im looking for someone to apply a good mod and obtain all the juice of this amp because im pretty sure that this module can give more than the actual performance (and even now its a very good performance), but I want to see where is the limit

 

[Skullar]

Apart of Fidelizer, anyone knows someone who's on this business and is able to mod an amp8? Im looking for someone to apply a good mod and obtain all the juice of this amp because im pretty sure that this module can give more than the actual performance (and even now its a very good performance), but I want to see where is the limit

It definately is not a limit. After modding it is beast. But if you dont want to go with fidelizer and eventually find someone else doing it, please let me know as i might send my amp9 to be moded if i like it

 

[Whitigir]

Apart of Fidelizer, anyone knows someone who's on this business and is able to mod an amp8? Im looking for someone to apply a good mod and obtain all the juice of this amp because im pretty sure that this module can give more than the actual performance (and even now its a very good performance), but I want to see where is the limit

The limit is from the modder as it based a lot on the actually experiences and the marks of references as of where one is based off on when you take into account the limited sizes. My own limits is the Amp8EX, and that is it ....Of course the Amp8EX is a lot more than your regular Amp8 in both actual performances (IMO) or....components quality/cost being used

 

[behemothkat]

A question to anyone who has AMP8EX and uses NeutronMP and can spend some time to check: I identified today a very strange symptom while listening DSD (image+cue file) with my DX228EX setup; my right channel had a VERY high floor noise (during listening, paused play, etc). When I exited from Neutron and started to play the same file with Mango Player, right channel noise gone (I means, when I run Mango Player noise was still there but then it gone right in 2-3 seconds).
Important to mention I was able to repeat that symptom again. However, noise does not come immediately when I started listening but after some time.
Last but not least, I didn't manage to get it with AMP9 - both players plays silently.

 

[Whitigir]

A question to anyone who has AMP8EX and uses NeutronMP and can spend some time to check: I identified today a very strange symptom while listening DSD (image+cue file) with my DX228EX setup; my right channel had a VERY high floor noise (during listening, paused play, etc). When I exited from Neutron and started to play the same file with Mango Player, right channel noise gone (I means, when I run Mango Player noise was still there but then it gone right in 2-3 seconds).
Important to mention I was able to repeat that symptom again. However, noise does not come immediately when I started listening but after some time.
Last but not least, I didn't manage to get it with AMP9 - both players plays silently.

Try Restart the player ? Neutron could be incompatible somehow ? When Amp8 was first released, this happened with Mango player too, then solved with firmware

 

[iMongui]

A

Try Restart the player ? Neutron could be incompatible somehow ? When Amp8 was first released, this happened with Mango player too, then solved with firmware

And are you able to be asked to mod? where are you located?

 

[behemothkat]

Yes, restart helped so far
I’m just curious to understand a “nature” of such noise (what does Neutron differently from Mango Player on audio driver or HW layer?)

Try Restart the player ? Neutron could be incompatible somehow ? When Amp8 was first released, this happened with Mango player too, then solved with firmware

 

[Whitigir]

A

And are you able to be asked to mod? where are you located?

I am in the US and I don’t

Yes, restart helped so far
I’m just curious to understand a “nature” of such noise (what does Neutron differently from Mango Player on audio driver or HW layer?)

it is just the matter of firmware and power distribution...similar to what I stated a while ago.