DIY Cable Gallery!!
Jul 4, 2010 at 7:47 AM Post #5,911 of 16,305
I use Creative EP630 earphones in bed to watch a movie or listen to some music before going to sleep. Being only 16ohm, there was a bit too much of hiss, both using the Fiio or not. This was solved with the following impedance adapter (22ohm). The resistors were matched with a multimeter. All parts came from some PC component I retrieved from the garbage, however, this costs less than 1euro to build. 
 











 
Jul 4, 2010 at 8:24 PM Post #5,912 of 16,305
Jul 7, 2010 at 5:15 PM Post #5,914 of 16,305
Here is my Dual Silver Wire LODs
 
 


Print this image for refference when building your LOD
 
 

 
Jul 7, 2010 at 6:03 PM Post #5,916 of 16,305
I use the Audio Ground with micro heat shrink so no change of short..
 
I may change........
 
Are all grounds just a ground??
 
Why is the audio ground a audio ground :)
 
 
Jul 7, 2010 at 9:49 PM Post #5,918 of 16,305
Is there an advantage to using a LOD over the minijack, besides coolness factor of course
biggrin.gif

 
Jul 7, 2010 at 10:05 PM Post #5,920 of 16,305
The line-level signal being unmolested by the iPod's attenuator.
 
Jul 8, 2010 at 10:44 AM Post #5,923 of 16,305
it's called ribbon cable - you can buy it anywhere
 
Quote:
How did you manage to get those wires to stick side by side of each other? or did the wires came like that, haha. Care to share where you got them?



 
Jul 10, 2010 at 12:54 PM Post #5,924 of 16,305
I made this for a forum member..
It has 20G silver wire and Neutrik pins which I shorten a 1/4" each..
I think it makes them look much better but no strain relief clamp but with 20G wire I think it will last..

 
Jul 11, 2010 at 9:04 PM Post #5,925 of 16,305
Finally finished my recable on my Grado's. I installed mono jacks inside the cups incase I ever want different cables. It is Blue Mogami with Carbon Techflex over it with Via blue plugs. I know there are some flaws in it but It looks nice and is the length I want!

 

 

 

 

 

Users who are viewing this thread

Back
Top