Sommer Cable 0,14 mm²
Rean NYS 231 BG x 2
Amphenol KS3PB-AU
Rean NYS 231 BG x 2
Amphenol KS3PB-AU
Sommer Cable 0,14 mm²
Rean NYS 231 BG x 2
Amphenol KS3PB-AU
Could you please tell me what's the exact model of the Sommer Cable you use?Hirose x Hicon
Buy what your local store has to offer. Take 0,14 mm² or 0,22 mm² (AWG 24 / AWG 26) flexible copper cable and some paracord 425 (typ2 with 3 cores).Could you please tell me what's the exact model of the Sommer Cable you use?
I hope I am not boring you guys.
My beloved Ultimate ears UE700's which is getting a little old, developed a cable problem.
Now these are over 10 years old, but I love them.
Problem was that where the cable enters each bud, right at the grommet, the outer sheath was getting weak and too thin, about to break.
My solution was to cut the cable about 15cm from each bud.
Got a safety pin and cut two 15mm studs from it. I shoved the studs through the grommet about 5-7mm with a tiny drop of superglue to make sure the stud stays there.
I then used some glue-lined heat-shrink tubes to go over the cable, the grommet and the stud - to keep everything together. it seems to work.
Recently Jays company was selling detachable remote cables for their Q-jays for only a fiver including postage - so I bought a couple.
I soldered the Jays (very thin and flexible) to the ends of the cables from the UE's - this time using a rubberized heat-shrink to cover the lot and create an ear-loop.
Here is the result. (I was tired, so not everything is to measurement)
I wish it was possible.Nice! I would recommend you solder a new cable directly to the drivers or explore the possibility of converting it to removable connector such as MMCX