Quote:
Skylab uses LCD-2's with a Mini TORII. Question for you all, I recall reading that the original CSP2 had a problem of getting too loud, too fast. Steve did something and created the CSP2+. I have the + model and mine has this issue. Was it a knob or something on my model that I just haven't figured out how to use yet?
TIA!
Your results might vary but for my CSP2+, I'm using that with high impedance Beyer DT880 (600 Ohms) headphones.
I don't have that too loud, too fast problem.
In fact, I initially had doubts about placing an order for my CSP2+ because of the lack of remote controls!
H/W, after I received it from Decware, I have found that the CSP2+ has fantastic dynamic range and does not require any more fiddling with the volume controls once you have set it up.
My CSP2+ settings are
7 Clicks clockwise for the volume knob in front.
Max 20 clicks clockwise for the L/R headphone input controls on the left side.
The L/R output volume controls on the right side do not affect your headphone output at all, i.e. I don't hear any difference on my headphones. The 2 L/R knobs are only used for adjusting the volume of the CSP2+ when you use it as a tube preamp.
Once the music starts, I do not have to adjust the volume ever again!
For me, this setting works for 99% of the audio music CDs I play on my Oppo-95 player.
Only 1 or 2 CDs require the volume knob to be set at either 6 or 8 clicks, but that is like only 2-3 out of the 70 audio CDs I have played.