One more question - is there a step-by-step guide for updating the firmware without the GOfigure app? The only one I found online was this here: https://www.moon-audio.com/files/chord/chord-poly-firmware-2.0.0.pdf
If I follow those steps, would it work:
Leave Poly connected to a WiFi network with internet access for 20 minutes.
Switch off and wait for P status light to go out then switch Poly back on.
Wait another 20 minutes.
Switch Poly off, wait for about 30 seconds, and then switch it back on again.
It doesn't say that a charger should be connected to it though.
UPDATE: Okay, after going through a couple of update cycles via the method above, I was finally able to see the device in Gofigure app. Unfortunately a lot of new problems appeared.
1. In the initial wizard, when I select Wi-Fi Normal, there's no Wi-Fi network showing at all (no matter if Poly is in Network mode searching for networks, or already connected to my phone's hotspot).
2. If Wi-Fi Hotspot is selected, it says that Poly will reset and enter hotspot mode, then app will close. Non of this happens though if I continue - Poly's P-Status led is still blinking in blue.
3. If I choose Bluetooth mode from the initial wizard, I'm actually able to finally go into the app's menu. This is where all gets weird - in the General settings I get the following:
There's no SD card inside the Poly at all, Firmware Version is showing as 0.0.0 etc. Even if I refresh the SD CARD database, nothing changes. I tried factory reseting it but it doesn't seem to do anything besides closing the app. After the initial wizard, it always takes like a minute for the Poly to connect to the app again (loading is too long).
I tried entering
www.poly.audio again to see the firmware version that way, unfortunately still nothing on the bottom of the website.
Any idea what's going on? Should I proceed by going through the manual firmware update procedure multiple times (following the same guide from moon-audio) until something changes, or it's pointless at this stage? And last question - is it normal for the Poly to take the exact same time updating itself (led changing from blue to green to red), which is around 20 seconds?