-
-
Yes, on the fence with Mojo 2.. but when pushed with the old maxim of if you're going to spend that much for portable use headphones of... -
jarnopp reacted to AussieMick's post in the thread Hugo M Scaler by Chord Electronics - The Official Thread with
Like.
You say, “never ends” like it’s a bad thing! -
jarnopp reacted to MarkParity's post in the thread Chord Mojo 2 Thread ___ [product released January 31, 2022 -- starting on page 95 of thread] with Like.
Indeed and over on a Sony DAP thread they believe a certain brand of Micro SD card gives an audible change to the sound as well. Placebo...
-
jarnopp reacted to xtremepsionic's post in the thread Dan Clark Audio E3 Review: Interview, Measurements, Impressions with Like.
After a similar amount of time, I also have similar impressions. In addition to that, the sound stage feels very coherent and natural...
-
jarnopp replied to the thread Chord Mojo 2 Thread ___ [product released January 31, 2022 -- starting on page 95 of thread].I disagree. If the source is sending bit perfect data, that is what you get at the DAC input.
-
Finally i have opportunity to try this can extensively on my local audio shop, i was pairing it with mojo 2 (all sample as brief...
-
jarnopp reacted to AussieMick's post in the thread Hugo TT 2 by Chord Electronics - The Official Thread with Like.
It’s not about bit perfect or data corruption. It’s about electrical noise is mixed signal systems. Any noise that travels from the...
-
jarnopp replied to the thread Chord Mojo 2 Thread ___ [product released January 31, 2022 -- starting on page 95 of thread].Toslink is better, and is considered the reference connection, as it can’t transmit any electrical noise (no electrical connection). The...
-
jarnopp replied to the thread Hugo M Scaler by Chord Electronics - The Official Thread.Yes. Feeding a 44.1 signal optimizes the mScaler as it’s doing the upsampling. Higher res files are fine, and will be upsampled, but...
-
jarnopp replied to the thread Chord Electronics ☆ Poly ☆ (wireless & microSD module for Mojo) ☆★►USEFUL INFO on 1st PAGE!!◄★☆.You can use an SD card (with UsB adapter) plugged into the glovebox port though, and that will be your best source in your Tesla.
-
jarnopp replied to the thread Chord Mojo 2 Thread ___ [product released January 31, 2022 -- starting on page 95 of thread].The charging circuit in the original Mojo would make that noise, especially when nearing full charge. I haven’t heard it with Mojo2, or...
-
Actually it can do both; there is a switch to connect the earth or not to the output voltage. Yes same applies - assuming the DAC is...
-
I jumped on the hype train and purchased the Noire X last week, hoping that it might replace my E3 at a much lower cost. My expectations...
-
Mojo 2 uses a 3.5mm not 4.4, so either go with the dual tip 1/4 and 3.5mm DUMMER or get a VIVO with 3.5mm in your desired length… I like...
-
It’ll be nearly identical. The AEON line isolates a bit better than E3, a couple dB, I think simply because E3 is bigger so there’s more...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
