I believe that Jason has said they will do the conversion on a case by case basis. I don't see any reason that they would refuse to do it for you. I am not sure the cost but should be very reasonable as it has been when I have had things repaired out of warranty.

If you don't really need the switch i would just get the PoE injector. I don't believe the is a big difference other than where the PoE is coming from.

Mine is the Security Gateway Pro model: USG-PRO-4 the full setup is USG-PRO-4 which feeds a Unifi switch 16 150W where it goes to my Access Point UAP-AC-PRO and a small switch in the office Unifi switch 8. This is the backbone and everything connects to 1 of the 2 switches, depending on where...

Here it is in mine. I have the 2G band set to low power and the 5G band to auto. This forces most things to connect to the 5G band. I found that if both were set to auto it would try and balance the load and so devices like my phone would connect only to the 2G as devices that stayed in...

Ubiquiti has a forum that people use for most questions and general talk. There is an option in the control for the access point to change the output power so you can put it in low, med, high, or auto for each 2.4ghz and 5ghz brands. I do not know if it has to be done with their software...

Are we looking for custom or from a store? Any of the main makers will be very good quality. Going custom is a whole different game. I will try and put more up later on it.

Which version of the Modi do you have? If it is a version 1, usb powered only, people have started reporting similar issues and not long after having the Modi die completely. The hub you have listed isn't a powered hub. While correct that if it shows the green light it has power a powered hub...

Just finally redid my setup. It is now more even as the speakers are parallel and towed in a little instead of being on each side of me as the computer displays were in the corner of the corner desk. Think I am done with this setup: Yggy>>Loki>>Freya>>Vidar>>B&W 805 Signatures and SVS SB1000.

Just redid the desk so new setup.

He is mostly siamese with some Himalayan and traits of Maine coon. His sister is purebred ragdoll. Both are humane society rescues.

My wife didn't believe it could make a difference. I played some things through a couple of the DACs I have and she could pick up a difference right away, in some cases quite substantial differences. She later questioned the speakers I got and I played some things on the new speakers and then...

So I had a new one today. Sitting and listening to music and I hear the clicking of relays. Look over and this little Schiit head is reaching down and turning the volume up on my Freya. Of course he was turning up "Another one Bites the Dust" by Queen. I think my time is near...

It is fed from one of the se outputs from Freya. One runs down to Vidar and the other to the SB1000. I then set the crossover and level on the sub to blend with the speakers. On the SVS subs don't use the preamp outputs from the sub to pass the signal through. Reason is SVS uses digital dsp to...

I am running yggy into a 2.1 setup. Mine runs all single ended right now. Yggy to Loki mini to Freya into a Vidar powering a set of B&W 805 Signatures with one of the outputs, and the other runs to an SVS SB1000 with the crossover and level set on the sub to blend.

Well this took a turn before I was able to get back. Unfortunately without actually being able to see and try things it is rather hard to see what is going on. I have had my issues with some of my Schiit products as well. I was getting interference in my Lyr2 when I first set it up and through...