How did you optimized it? Could you please share your parameters? I pretty much use the default setup with my ADI2 currently.
The major first step is experimenting with the various degrees of freedom in head placement.
The short video from the Raal website is sure worth a look in this regard:
I would not call myself a bass-head, but do like solid base and fundamentals in my music.
At the same time I’m generally not listening very loud, vocals in the music are a bit louder than normal humans talking.
Typical music level ca. 65-70 dBA Leq (long term average), with peaks up to 95 - 100 dB SPL.
The power amp is not challenged much: ca. +20 dBu or 10 W / 6 Ohm Peak typically is the very highest I observe.
I love music with lot’s of dynamic, try to avoid contemporary, dynamically over-squashed remasters.
First based on measurements (on my own head, mic inside my ears), then hours of fine-tuning I made an EQ setting that adresses all mentioned Issues, without overdoing it or killing SR1a’s character.
Specially the bass becomes viceral in a way I did not expect from SR1a.
The EQ slighty addresses midrange and treble too, this is very personal I guess.
Doing more in the mid/treble range sounds too much for me.
Treble is better controlled by positional variations, than excessive EQ.
With the EQ the bass and fundamentals sound punchy, compact and present in a way I did not expect from SR1a.
The fastness stays, combined with a significant gripe on the related instruments.
No hint of tizzy or thin sounding any more.
Positioning, probably quite personal, but another person found similar settings favorable too.
• Driver flaps angle: L 27 ° R 27 ° few millimeters away from pinnae contact. I made little card-board angle stencils to set this up.
• Driver horizontal position: usually ca. 5 mm to the front from the back-most possible position, very tiny bit more forward than the upper-mid-hottest position. I do use this to regulate the treble amount.
• Driver height: center driver ca. aligned with ear-canal entrance.
• Wearing angle (seen from the side): upper part, headband, slightly backwards, ca. 10 °.
• Fit: tight fit, still comfortable, don’t need the back-strap.
Raal SR-1a EQ04
RME ADI-2 Pro.
THE EQ DOES NOT CONTAIN BAFFLE STEP COMPENSATION as the standard SR1a amp interface already has it.
There are EQ bands left to do this, in case needed.
Baffle Step Compensation would be:
-4.5 dB / 1000Hz / Q=0.5 / High Shelf.
Gain / Freq / Q / Type / (comment)
.. dB / Hz
+5.5 / 130 / 0.8 / Shelf / (adjust gain to taste)
..
n.a. / 25 / 1.8 / High Pass / (High Q boost the lows SR1a is capable, removes below)
-2.0 / 2.1k / 1.5 / Peak / (vocal presence)
-1.0 / 6.3k / 3.5 / Peak / (harshness)
-2.5 / 9.1k / 5.0 / Peak / (Sibilants)