[bperboy]

Man, that Plexi case is nice! Especially the matching knob, I think it ties everything together very nicely! It probably looks even better in person too! Nice job!

 

[Tedro]

Goes along with my other adventures:

M3, PPAv2, Millet Hybrid

 

[colonelkernel8]

Someone likes acrylic cases. Thats good man. I think I will be making the venture into wooden cases.

 

[Bjornboy81]

Tedro, those look great. Very well done!

Here's a CMoy I just finished up. I bought the board from Zigis and put it in a Hammond Case. Sounds great!

 

[Polaris111688]

Extremely sweet case work, Tedro! I was never good at case work...

 

[Ferrari]

Not finish the case work yet, but here is some pics of the work in progress

.

 

[colonelkernel8]

That is so CLEAN! I love your work Ferrari, and I love that case.

 

[A1095]

I just completed the Ti Kan SDS upgraded amp. Installed in a salvaged Dynaco PAT4 preamp. All boards hard wired on RS perf boards. Matched output pairs ordered from AMB and most others from the usual... Digikey and Mouser. Alps Black beauty (100K) up front with a BB opa2134 socketed. I plan on trying the AD8066 opamp in the future. I'm running 80 mA. bias with +-15V. The LM317 and LM337 run on RS heatsinks. I was concerned, at first about the regulator temps., but the heatsinks measure just under 50 deg. C. Seems to be a safe margin.
All I can say is that it is extremely clean and dead Quiet! I know this design is a bit dated, but it is quite capable and fit quite well into the old Dynaco chassis. Still need to figure out how to create some venting on the top cover.

All the Pics: http://s76.photobucket.com/albums/j7...adphone%20Amp/

 

[bperboy]

Very nice on the SDS! Did you do that all from the schematic?

 

[A1095]

Yes.......... all hard wired from the schematics. I wanted to seperate the supply sections from the audio board as far as possible. Supply noise is not an issue here.

 

[bperboy]

Very nice job! props to you for not using a PCB!

 

[Bones55]

Well, here is my first build. CMOY in an altoids case.

Here is the amp during my first build, a jumble of wires and exposed connections. Worked beautifully, but looked like crap inside.

So, i rewired and heatshrunk the whole thing.

The finished setup, with my Zen and the Zen LOD I made.

Now to move on to something more interesting.

 

[qpoiz]

Quote:

Originally Posted by Bjornboy81 /img/forum/go_quote.gif Tedro, those look great. Very well done! Here's a CMoy I just finished up. I bought the board from Zigis and put it in a Hammond Case. Sounds great!

Hey bjornboy81,

did the board you bought from zigis fit on the mounting holes of the hammond case? I was checking out the blank PCB for that case at Mouser and its $9...

any pics of the inside?

 

[Bjornboy81]

qpoiz,

No it doesn't fit the mounting holes. The board is held in place by the nut on the pot and connectors. I can get some shots of the inside later today for you.

 

[vixr]

here is my new Millett MAX (V.2 Proto) WOO HOO!!!