Modifying WM1Z/A
Status
Not open for further replies.
May 19, 2020 at 2:53 PM Post #1,981 of 3,042
Ufff, so much fun, I’m jelly 😐 I think I need a new hobby 🙃
I like the fact that, at any given point, I can totally damage a $2,000 plus unit...
:astonished: :grin:
 
May 19, 2020 at 3:54 PM Post #1,983 of 3,042
My elna 47uf is measuring same as my Audionote, at 50uf...
IMG_20200519_154740.jpg
So the only difference between them is the voltage rating..
Elna at 10v, & "AN" at 16v...
Hmmm.

Edit**
Actually, all the "AN" are reading slightly below their values at 49.6 to 49.8uf, so they are closer to 47 value than the elna, which are all at 50uf.

IMG_20200519_154740.jpg.
 
Last edited:
May 19, 2020 at 4:02 PM Post #1,985 of 3,042
All of these Electrolytic has 20% tolerances :wink: ... won’t surprise me if 47uf measure into 57uF

I calculated my tester accuracy is rated 4% off plus 3point so a variation of 5uf.
Screenshot_20200519-153012__01.jpg

Regardless, it looks like the "AN" are a closer fit(!) than the elna...
Dam decisions!
:)
 
Last edited:
May 19, 2020 at 4:05 PM Post #1,986 of 3,042
won’t surprise me if 47uf measure into 57uF
this is true I have noted that the longer I leave the tester on the leads it slowly rises .01 increment, very slowly..(!)
Took about a full 2minute to reach 1uf more...
 
May 20, 2020 at 2:20 PM Post #1,987 of 3,042
Has anyone used hotglue yet?
Screenshot_20200520-133924.jpg
I may put a dap to hold any caps steady.
The problem is it is hard to remove if make mistake.
 
May 20, 2020 at 2:25 PM Post #1,988 of 3,042
Has anyone ever used the NFC antenna?Screenshot_20200520-142449.jpg
 
Status
Not open for further replies.

Users who are viewing this thread

Back
Top