Seld
Head-Fier
- Joined
- Dec 1, 2010
- Posts
- 82
- Likes
- 18
Hi all, headfiers.
I would like to have an advice before breaking all my toys.
I'm actually enjoying my LCD2 with the Wa6... But I would like to try it out with a speaker amp.
The only amp I have is a Musical Fidelity XT100 (with a XRay-V8 combo cd drive as source).
The amp technical details are these:
power: 50w into 8 Ohm ...... or ..... 80w into 4 Ohm
voltage, RMS ...... >20 volts 20Hz to 20kHz
voltage, peak-to-peak ....... 67 volts
current, peak-to-peak ....... 30 Amps
pre-out impedance ........ 47 Ohm
Do you think I could drive the LCD2 directly from this amp? or may I damage it?
And building the cable, can I use the original cable of the LCD2 cutting the jack or do I need a power cable o something else?
Thanks a lot for your attention and you suggestions!
F
I would like to have an advice before breaking all my toys.
I'm actually enjoying my LCD2 with the Wa6... But I would like to try it out with a speaker amp.
The only amp I have is a Musical Fidelity XT100 (with a XRay-V8 combo cd drive as source).
The amp technical details are these:
power: 50w into 8 Ohm ...... or ..... 80w into 4 Ohm
voltage, RMS ...... >20 volts 20Hz to 20kHz
voltage, peak-to-peak ....... 67 volts
current, peak-to-peak ....... 30 Amps
pre-out impedance ........ 47 Ohm
Do you think I could drive the LCD2 directly from this amp? or may I damage it?
And building the cable, can I use the original cable of the LCD2 cutting the jack or do I need a power cable o something else?
Thanks a lot for your attention and you suggestions!
F
