I have 2 UTWS5, one connected to an Avalon IMR and another to a Dunu SA6 MKII
I just updated the avalon to version 1.73 first, everything is correct.
Then I update the Dunu SA6 and while it is updating, the Avalon that is in its box just updated, does nothing but connect and disconnect.
I have opened the box, I have pressed them against the contacts and I have closed them again, it seems that at the moment they have not connected again, at least in the last two minutes, is it possible that I had placed them wrong in the box? We may wait and see.
It has reconnected, I think it is now worse than before
On the other hand, with the Dunu SA6, it doesn't happen...
Still, I think that's not the worst thing for me.
The worst thing is that since the update to 1.71 when I put the hooks in the box the R side gets turned off. when I reconnect them, the R side has turned off and the L side has dropped a lot of battery, so when the R side is turned on, it is at 100% but the L side is much lower, and not only that, but it also stops. runs out very fast.
This happens to me much more and in a more pronounced way with the UTWS5 connected to the Avalon than with the one connected to the Dunu SA6.
Could it be in bad shape?
I'm going to swap the connected iems and see what happens, I'll keep this firm for a couple more days but if that's the case I'll go back to 1.5. or 1.4 at least with one of the two.
With LHDC at 1.4 it sounded great.
The volume thing, in principle it doesn't bother me, I don't usually turn the volume up that much.
PS: I have put both to load and they keep connecting and disconnecting both.
As soon as I stopped charging them they disconnected from the phone, but they keep reconnecting after a while.
At first, this new firmware doesn't solve anything but adds new problems, so I'm not going to wait, I'm going back to the old firmware, I think that 1.4 was the one that sounded best with the LHDC.