Sand the "lip" of the shellhmm, mine do not seem to fit with mx500 shell
also, if the shell not have any cut, add one at the top or bottom and orient voice coil hole of the driver where this cut is
Sand the "lip" of the shellhmm, mine do not seem to fit with mx500 shell
Or use gluehmm, mine do not seem to fit with mx500 shell
but how to remove the speaker from the front protective panel? tried to insert with the old panel into the case from stellar, the magnet is too wide. while in old buildings, the native damper, paralon, died, I replaced it with half a cotton swabЛучше в классической оболочке MX500. Он у меня в обеих оболочках. Я откажусь от тех, что в прозрачной оболочке Stellar. Кстати я тоже поменял лицевые панели
Removing a speaker from the faceplate is always risky.but how to remove the speaker from the front protective panel? tried to insert with the old panel into the case from stellar, the magnet is too wide. while in old buildings, the native damper, paralon, died, I replaced it with half a cotton swab
Why did you want to change faceplates on MX760 drivers?indeed i broke my mx760 driver :v
solder touched the faceplate a bit when i was soldering the driver :vWhy did you want to change faceplates on MX760 drivers?
You had to follow my advice or fury's
@furyossa know better TG-38s. MX760 drivers sound very good in MX500 shellsolder touched the faceplate a bit when i was soldering the driver :v
might buy another pair.
or tg-38s
If you like big soundstage TG-38s is great choice. More about it https://www.head-fi.org/threads/earbuds-round-up.441400/post-16445306solder touched the faceplate a bit when i was soldering the driver :v
might buy another pair.
or tg-38s
Well after a day and night full of Halloween partying I thought, what was a better way to end my night (morning) than finally recable my Sony HPM-62?
So, inital impressions, I understand why ClieOS put his recabled HPM 62 where he did. It has very nice soundstage and above average detail but is bright and forward. Gonna mess with it some more.
@BloodyPenguin already has dibs to be the first person (After me) to try them out! My only complaint is the shells had these built in guides for the stupidly thin cable, so I broke them off and it turned out to be one of the clips, so there's a little electrial tape there now
Took like 5 minutes to do, everyone should be DIYing buds! It's too easy.
I want to create an earbud with sound as close as it can be to the yincrow x6.
What drivers should i use?
There are these in AliExpress that say the are vido drivers.
For shells i guess some standard mx500 will be fine?
https://m.aliexpress.com/item/4000271073576.html?spm=a2g0n.productlist.0.0.796e3ac6WdubcQ&browser_id=cd513dc85e7143e8b4fc4a35e20ece48&aff_trace_key=&aff_platform=msite&m_page_id=17bda46d1536fb899271166adf1515a76e58d16544&gclid=&_imgsrc_=ae01.alicdn.com/kf/Hc8eb59cf720041eb9fa2c923d9584faf2.jpg_640x640Q90.jpg