robert123wr
New Head-Fier
- Joined
- Sep 19, 2013
- Posts
- 21
- Likes
- 10
How can I make a TF10 cable?
Does anyone know where to buy para cord sleeve for 26awg 4 core cables ?
I believe 750 paracord should fit that. You should be able to find it on eBay or from a quick Google.
Ok thanks. This 750 paracord is core-less for the wire right ?
There is nothing inside of paracord except the white string that you're supposed to remove, so yes.
Hey guys.
I've asked this already, but nobody answered me, so I'll ask again so I know what to do.
I know 4 rings means TRRS, but if a cable has TRS or TRRS connectors, does that make it balanced?
I already have my headphone cable with TRRS 3.5 mm and TRS 2.5 mm, so if it's balanced already, I'll switch to recabling some other ICs or in ear hp.
Also, how can one measure the benefit of a newly built cable or compare two different cables? Spectrum analyzer? Oscilloscope? Recording my voice with an external microphone THROUGH that cable and create a matlab function that measures SNR and other stuff?
Thanks for the help.
Regards.
Your questions are way too board and require quite a bit of in depth information to properly answer. Thats probably why no one has taken the time to answer. Spend some time googling, learn what "balanced" actually means and whether or not cables actually make a difference at all.
A headphone has 2 signals going to it. It requires 4 wires and 4 pins on the connector to be balanced. All that means is that their is a separate ground for the left and right drivers. I don't know how your headphones are wired internally, if the TRRS jack in the headphones has 2 wires going to each driver then you can make a balanced cable fairly easily. If the stock cable has 4 wires in it and two are connected to the ground in the TRS then you can just replace it with a 4 pin or dual 3 pin connectors and connect it to a balanced amp. Now you'll need to use an adapter to use it with a standard amp.
Balanced interconnections are not the same as balanced headphone cables. The former uses a hot, cold, and a ground reference while the latter jus indicates a headphone with separate grounds.
Unless you have a damaged cable or seriously undersized (the latter is common on cheaper headphones and some nice ones) don't expect a difference in the cable. Worry about aesthetics and feel. Dynamic drivers don't need more than 26awg generally 24awg being a little more durable. Orthos that require a lot of power benefit from 22-20awg wire.
Obviously I don't believe in the "value" of things like silver cables and über expensive plugs without proper cable clamps.
Thank you for your response. Kind of understood it all. My headphone uses a single source-hp cable and there is another cable going under the headband that connects the 2 drivers. Considering the cable has built in microphone, it can be, 1 ground, 1 microphone and 2 signal wires.
Hi, I recently made my own cable. However, after finishing and testing it, I found that due to both ground cables being attached to the same ground pin in the 3.5mm jack, it transfers a bit of each channel into the other (only about 20% volume). I figured I could attach some diodes to the ground wire so that it'll prevent sound from coming up it, but it just distorted the sound, and I don't know what else to try. Any help is appreciated!
It doesn't really work that way... just consider that the ground is attached at the connector of all headphone cables and inside all unbalanced audio equipment.