wolfetan44
Headphoneus Supremus
- Joined
- Mar 27, 2012
- Posts
- 4,407
- Likes
- 84
I bought 10 feet of Mogami 2534 to make a HD650 cable, still waiting for it to come.
Typically:
Tip - Left
Ring - Right
Sleeve - Ground
So, you would wire your female to male:
Female Tip to Male Ring
Female Ring to Male Tip
Sleeve to Sleeve
Typically the tip is the farthest forward solder point on the internals of the connector. On most you can tell that it's connected to the center of the plug.
I recently bought the vsonic VSD1 and the best way to wear the is over the earpiece in the right ear and the right earpiece in the left ear. Now i am looking for some kind of plug/adaptar to swaps the channels. If it does not exists can i make it myself?
I was thinking of using a male 3,5 mm and a female 3,5 and connect them in a way that it will change the left and right channel. Only problem is how to i know wich one is left or right at the female plug.
i know that tip is left etc. but the how to i know wicht one is wich with a female plug. with a male plug i even can use a multimeter if i am not sure. both the tip and ring connection look the same
If you have a continuity tester (or multimeter) and an uncabled male plug lying around: Map its solder points, plug it into the socket, and then map the socket's solder points.
My wire samples have arrived!
Now I have an understanding of the common Mogami and Canare numbers.
Thanks!
Much Appreciated!
Sent from my HTC Desire HD A9191 using Tapatalk 2
I need some help, I have the female mono jack but I cant tell which tab is the signal and which one is the ground
Heres a picture of it: