hieukm
Head-Fier
- Joined
- Jul 30, 2005
- Posts
- 99
- Likes
- 17
That sound great. What improvement could you recall when putting the Blu2 on a separate circuit and on your RSA Dimitri.I have an analogue and digital circuit, supplied from a DFS 2 040-2 / 0.03-F Audio residual current circuit device and two separate GigaWatt G-16A 2P circuit breakers in the consumer unit. 4 mm² screened power cables run from here to an analogue power socket at the front the listening room and a digital power socket at the side. The power cables are separated as much as possible in the attic. One runs at the front of the attic and the other at the rear. I can have 2 separate circuits as the Opto-DX eliminates any potential ground loops. The Heisenbergs and Dave are powered from the Analogue circuit via an Audioquest Niagara 7000. The Blu2 and digital sources are powered from the digital circuit via my original conditioner, a RSA Dmitri. The Opto-DX also allows physically separating analogue and digital components.
i felt putting Blu2 on a separated circuit/isolation transformer and not mixing it with digital gear would yield further benefit
I will experiment putting the Blu2 on a separate balanced isolation transformer on a separated circuit from my other gears which already on isolation transformer and power conditioner.
DFS RCB do bring a taste of what low impedance electronic can do to your system. Whats the benefit of Gigawatts MCB? I hope its small enough not to trigger upgradititis
Last edited: