-
-
Jawed replied to the thread CHORD ELECTRONICS DAVE.You tempted by OMA?: https://oswaldsmillaudio.com/imperia OMA makes amplifiers to match, too: https://oswaldsmillaudio.com/special-k -
Jawed reacted to gshyoung's post in the thread Hugo M Scaler by Chord Electronics - The Official Thread with
Like.
OK, on further testing, this is what I've found. One of the BNC cables is dodgy. When I have this cable plugged into either of the BNC... -
Jawed replied to the thread Hugo M Scaler by Chord Electronics - The Official Thread.Here's a test you can try: With HMS connected to Hugo 2, disconnect one BNC plug from HMS Tell us what colour light you get Re-connect...
-
Jawed replied to the thread CHORD ELECTRONICS DAVE.Does the design brief for Ultima DAC include headphone output, or is it purely a fixed level DAC?
-
Jawed replied to the thread Hugo M Scaler by Chord Electronics - The Official Thread.705.6/768KHz sampling rates are the highest that the dual-BNC interface supports (same, too, for USB as it happens, with Chord DACs)...
-
Jawed replied to the thread CHORD ELECTRONICS DAVE.I suppose the Ultima DAC wouldn't be any neater than the system you're selling...
-
Jawed replied to the thread Hugo M Scaler by Chord Electronics - The Official Thread.In the past you've said that switching noise from a switched-mode power supply is not really a problem for your designs, because it's...
-
Jawed reacted to pkny's post in the thread Hugo M Scaler by Chord Electronics - The Official Thread with Like.
Hi Rob (@Rob Watts), I recently purchased a Mscaler. It is an amazing unit! It transformed my Hugo2 into a smooth, detail, and...
-
Jawed replied to the thread CHORD ELECTRONICS DAVE.I ran a pair of floorstanding speakers direct off DAVE for a few months. I've posted about it, years ago... 2W from DAVE into the La...
-
Jawed replied to the thread CHORD ELECTRONICS DAVE.DAVE direct into your La Scala speakers (from the RCA sockets), with no power amp should work too...
-
Exactly what happened to mine. Replaced the batteries in 2020 and it works fine since then. The AC adapter can be checked with a...
-
When the battery dies, hugo fails to start up properly and or at all. Any light can be blinking, depending in what fase of the starup...
-
Jawed replied to the thread Hugo TT 2 by Chord Electronics - The Official Thread.I'm going to presume that this means your KEFs are sitting very close to the wall behind them, presumably either side of a computer...
-
Jawed replied to the thread Hugo M Scaler by Chord Electronics - The Official Thread.In this post I document connection problems with TOSLINK caused by the alignment of the transmitter...
-
Jawed replied to the thread My Choral housed Chord Mscaler.Very nice work. For optimal sound quality I suspect 1m or more spacing between your Choral M Scaler and DAVE will be worthwhile.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
