- Joined
- Oct 14, 2013
- Posts
- 28,350
- Likes
- 32,189
Still waiting ? your is tomorrow ?D-day...
Still waiting ? your is tomorrow ?D-day...
Est end of the day...Still waiting ? your is tomorrow ?
now here is a problem.. I dont want to let it burn in...Above is good!
Lol! It is fun to ride along . I love doing thatnow here is a problem.. I dont want to let it burn in...
Did you get a chance to try another amp module yet? Same result? Then you probably need to contact Paul to get your DX220 fixed unfortunately...Does anyone have a problem with the volume knob? Any direction (clockwise or anticlockwise) would just increase the volume.
Didn't happen before I try the AMP8EX. I did make sure I was grounded before I open and replace the amp. I also tried swapping back to the old AMP8 and the volume control still broken.
I was on firmware version 1.13.202, upgraded to 1.15.233 and volume control is still broken. Also tried to "reset all" the device and still broken.
Is there anything else I can try to fix this?
Did you get a chance to try another amp module yet? Same result? Then you probably need to contact Paul to get your DX220 fixed unfortunately...
If it is unique to the AMP8EX then Paul can hopefully get that taken care of as well.
Cheers,
Tim
Interesting. I reverted back to 1.13.202 because of issues with the current FW and large drop in output when EQ is turned on. It was a bit of an obstacle course to go back but eventually got it done.Yes, I tried the non EX AMP8 and volume control is still broken.
I will try to swap to AMP9 later today, I suspected this has something to do with software volume control with AMP9.