Lake People Phone-Amp G109-P

General Information

The G109-P was developped with the target to enable highest transmission quality for low- , medium- and high-impedance headphones.

Due to its specific, variable, low-noise and low-distortion circuit design especially optimised for dynamic headphones,
the G109-P fulfils even most sophisticated demands.

LOW-NOISE (-101 dBu A-wtd)
because of low internal gain.
Therefore the self generated noise from the amplifer is not audible.

HIGH OUTPUT VOLTAGE (aprox. 19 V eff into 600 Ohms load)
through 60 Volt internal operating voltage.
Therefore best suited for high impedance headphones.
Over 90 % of all headphone amplifiers in the market offer not half that voltage !!

HIGH OUTPUT POWER (approx 2000 mW into 60 Ohms load)
because of powerful amplifiers able to deliver much more current a headphone needs.
Therefore best suited for low impedance headphones and even magnetostatic cans !!

HIGH DAMPING FACTOR ( >250 relative to a 50 ohms load)
through lowest output impedance.
Therefore best suited for full control even over critical headphones
with the garantee to have flatest possible response.


- Balanced inputs with gold-plated Neutrik XLR connectors
- Unbalanced inputs with gold-plated ALPS cinch connectors
- PRE-GAIN = switchable input gain in three steps
- DC-coupled (switchable)
- ALPS RK27 High-Grade volume control
- High-Quality op-amps in the signal path
- High-quality MKP capacitors in the signal path
- 0.1 and 1% metal film resistors throughout the unit
- Discrete-design power amp with 4 transistors per channel
- 2 silver-plated Neutrik headphone outputs
- Relay-based headphone output cutoff
- Toroidal transformer
- Large filtering capacitors in the power supply
- Switchable ground lift
- Aluminium case, black anodized
- Aluminium front panel, black anodized, silver silk screening
- Dimensions: 168 x 49 x 145 mm (W x H x D)


There are no comments to display.