Bingturong
Previously known as VitalB
Not exactly, you'll need to measure the bias voltage before the ballast resistor which, if I'm correct, for the SRM-T1 are the two last resistors on the bias section of the board before the bias wire (coloured grey) goes to the output. So you'll need to open it up and measure it from the bottom of the board.I just bought a pair of SR-009. When plugged into my T1 (recent serviced by Stax) one side is silent.
Before sending them back, my dealer has asked me to check the bias voltage of the T1. A local electronics engineer is going to help me do this without killing myself.
I have no clue about electronics. Is it sufficient just to put a multimeter across the bias output and earth? Or it life more complicated than that?
TIA