Recent content by Pyriel0

Quote: For $30 I can deal with a couple restrictions.  

People are just freaking out. One person says something and its like scaring an animal and watching a stampede start.   The HE6 takes about 1/4 the voltage of a k1k and a little more than half the current. Its 1/8 the power needed to drive a k1k.     K1000 101 db  512mW 120 ohm 7.84V...

Signal level is the voltage going into the headphone. 1000 mV = 1 volt.

Just means more time for a good 507 vs HE6 comparison. 

Quote:

I am not doubting you this is an honest question. Have you only heard the stax transformer boxes or any customs? I have been toying with the idea of trying stax but I would buy the x75 plitron electrostatic step up transformers to use with my amp. I have wondered for a long time if a high end...

I've never heard mine humming. Hopefully it didn't get internal damage during shipping. I just bought some wire and a 4 pin xlr from parts express to make my adapter. I just leave the 4 pin coming from the F1 next to my pc monitor so I don't have to worry about connecting/disconnecting from the...

Now I'm just waiting for the first time he uses it for a few hours and then puts his hand on it lol.   You mean a mechanical hum or you hooked the headphones up and heard noise through them?

Does anyone know the impedance / sensitivity of the new version since at least the latter has changed from the loaner pair? Sorry if it was posted, I haven't read the last couple pages.   Edit: Nevermind supposedly its about the same sensitivity as the he5-le from the post in the EU thread.

The K1K easily beats the the K701 at speed. Listen to #41 by Dave Matthews Band from 2:30 to 3:00, especially from 2:48 to 2:55. On the K701 things begin to jumble and just become a lump of noise. On the K1K every instrument is more separated and easy to pick out. This is from listening to both...

Quote: The only headphone amp I use is the lavry headphone out anymore. I haven't really sat down and compared the da11 hp out to the firstwatt outputs. Its more just for peace of mind on my end anyone lol, to make certain I know whatever I am listening to isn't being held back so I don't...

Quote: You can as long as you have 2 wires going to each driver(balanced wiring). I listen to my K701 and DX1000 from my Firstwatt F1. I have to put an 8 ohm resistor across each output with the DX1000 though because they are soo sensitive and I have to turn the volume down a bit to use...

Describing how a headphone sounds will naturally take comparisons to other headphones. I, for one, am interested in how the he6 sounds compared to the lcd2, along with all the other high end headphones out.

For anyone else on the loaner list that has an LCD2, how does the HE6 compare to it?

Probably a diy headphone with these.