Recent content by MattISO
  1. M

    Best IEM tips?

    OK Thank You very much.
  2. M

    Best IEM tips?

    I need Silicone ear tips with treble roll-off similar to Foam ear tips to tame bright IEMs. Any recommendations?
  3. M

    Output Impedance and IEM Impedance

    Ok Thank You very much.
  4. M

    Output Impedance and IEM Impedance

    I want to use the TinHiFi T2 IEM to listen to my guitar through the headphone output of my guitar amplifier. The IEM has an Impedance of ~16 Ohms and the Headphone Output of the guitar amplifier has an output impedance of ~32 Ohms. Based on these measurements of the IEM, Impedance Curve...
  5. M

    Best IEM tips?

    Ok Thank You.
  6. M

    Best IEM tips?

    Looking for tips that will least affect the frequency response of an IEM. Currently looking at the Acoustune AEX07 and AZLA SednaEarfit MAX. Anyone with experience with these for my use case? Any other recommendations? As Reference: This page (AEX07)...
  7. M

    Reply to review by 'MattISO' on item 'Questyle M12'

    @OspreyAndy OK Thank You very much for the advice.
    • MattISO
    • Head Gear rating reply
  8. M

    Reply to review by 'MattISO' on item 'Questyle M12'

    Great review as always. I've been looking for a reasonably priced, clean, transparent, low noise/distortion, near-neutral sounding, dongle DAC to pair with an external headphone amplifier and planar IEM. I've narrowed down my options to this DAC (Questyle M12) and the Helm Bolt. Considering my...
    • MattISO
    • Head Gear rating reply
  9. M

    Output Voltage of Amplifier + DAC

    TL;DR I did not get it, but eventually figured it out (I think) and will probably just have to get a Desktop DAC and Amp :/ OK Thank You very much for the response, I think I get it now. As for my gear, I want to get the Tin Hifi P1 Plus, a planar IEM. Technically it should be fairly easy to...
  10. M

    Output Voltage of Amplifier + DAC

    Another question. Even though my amp is set to unity gain and isn't amplifying the signal from the DAC, it's still outputting power (mW) to my headphones (the load) to drive them correct? For example, if my headphones needed 1000 mW of power, there would still be a benefit to using a 2 volt...
  11. M

    Output Voltage of Amplifier + DAC

    Thank You for the reply.
  12. M

    Output Voltage of Amplifier + DAC

    I'm looking to get an amplifier to pair with a DAC. The DAC should output 2 volts to the amplifier. The Specs of the amplifier are: Output Level: 11 Vpp / 3.889 Vrms @ Med Gain Input Sensitivity: 4 Vrms @ Med Gain Gain: -0.1 dB @ Med Gain Output Power: 1200 mW @ 16 Ohms and 1400 mW @ 32 Ohms...
  13. M

    How do I stream HiFi/Hi-Res Music?

    Ok Thank You for the advice.
  14. M

    How do I stream HiFi/Hi-Res Music?

    Thank You for the response.
  15. M

    How do I stream HiFi/Hi-Res Music?

    Can I just go Laptop > USB-C > DAC > 3.5mm > Amplifier > IEMs/Headphones then just set the sampling rate in windows and stream using Tidal/Qobuz? Would I need something like Roon, Audirvana or Foobar? Are they necessary or are they just beneficial?
See more
Back
Top