J Ottawa
100+ Head-Fier From Ottawa, Canada
- Joined
Latest activity Postings Classifieds listings Classifieds feedback Head Gear Reviews About
-
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.An incredible journey to a solution. Thanks for sharing!
-
J Ottawa replied to the thread Schiit Midgard - Impressions Thread.As a newbie I had to double check what that XLR connector was all about. It is a 4 pin XLR connector and I had to double check all that...
-
J Ottawa reacted to Xerosnake90's post in the thread NITSCH x Schiit Pietus Maximus Release/Impressions Thread with Like.Hey everyone, I'll be snatching up a Bifrost 2/64 as soon as someone decides to get rid of theirs. I'm thinking of upgrading my...
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.I haven't read everything since we are exchanging messages, but have you tried reversing the AC blades of the RME ADI-2's power supply...
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.It is perplexing for sure. To wit, the Benchmark AHB2 is a very quiet power amplifier and the RME ADI-2 DAC FS comes in at a very low...
-
J Ottawa replied to the thread NITSCH x Schiit Pietus Maximus Release/Impressions Thread.There was a time when maximum power transfer occurs when source impedance = load impedance = ohm's law calculations in a series circuit...
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.I did a bit more reading. XLR outputs: RME is (+ HOT) and (- Cold); Ayre is (+ non inverting) and (- Inverting). All good. Question...
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.I was curious about your amplifier and came across a review that states that there is power conditioning on board your amplifier and...
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.I've dealt with a bad hum on a Heathkit AA-151 tube amp rebuild; along with improper capacitor selections. It took me 2 weeks to...
-
J Ottawa replied to the thread RME ADI-2 DAC Thread.It is a challenging issue for sure and it could be the AYRE gear is compatible between the units and finding a proper return feed that...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…