Just got a used TA-26 and some tubes to pair with my HD600.. tube rolling can definitely cost more than the amp itself!

I use this one to connect my iBasso DX90 to Mojo: https://penonaudio.com/3.5mm-coaxial-cable-for-chord-mojo-dap.html?search=coax%20cable

i've got a similar setup with hd600 and dca aeon 2 open as my main headphones on this rig.. sourced from a bifrost2, i find that I need to EQ the bass down a bit on the a2o, but the the hd600's are good as is since this is headfi.. i'm tempted to try out an OTL amp at some point to see how diff...

thanks for the comparison! I have VE monk as well so I can compare the Zen against it to get an idea on how the bass regions will compare

hi all! has anyone compared the tgx earbuds to VE earbuds? I own a pair of 1st gen VE Zen earbuds, so I was wondering how these compare to them thanks!

nope i don't know the weight, go read the first post

here is a 3.5mm to 3.5mm coax cable that i use with my iBasso DX90 and mojo: 3.5mm coax cable here's an example of (MBP) toslink mini to toslink (mojo) optical cable that will work with most 2016 or older MacBook pro models: optical cable and for most PC motherboards, you would use a toslink...

are you able to try connecting to your mojo using coax or optical? depending on your mac model, it may have a dual functioning headphone & (mini?) toslink jack for optical out sounds like a usb port issue that i’ve seen others report in this thread, and those have been resolved/repaired by chord

i can’t tell if the cups were replaced as i can’t visually tell if these are new or original.. but the pads definitely feel firmer than they were before the repairs as i’ve had these for about 1.5years

my repaired A2O arrived today, they mentioned that the imbalance was repaired and it feels like newer (firmer) pads were installed.. will see if the occasional imbalance issue ever comes back again mine doesn’t seem to sound any different than before so my issue may have just been imbalance

not yet, it was thanksgiving in usa last week so i am expecting perhaps an update this week

i had a similar issue on my A2O from May 2020.. i reached put to dca and they immediately provided RMA number for me to start the repairs process.. my A2O is currently in their hands now so i will post an update when i hear from DCA on the issue

I think my issue may be the left driver and/or the connector.. as swapping L/R cables or using new Hart cables always resulted in the left driver having volume problems. I've also had the left driver's volume go from 100% ->20% -> 100% within minutes while music is playing. I've contacted DCA...

since the BF2 has a curved top edge at front, I believe the rubber feet of GLMK2 will just fit on top with flat part of the BF2 (haven't confirmed since everything's plugged in and settled) with the volume knob protruding in the front over the BF2 also, since I leave the BF2 on 24/7, I don't...

my A2O had the same left driver with lower volume issue and for me it's the stock cable, because when i swap the L/R cables the right driver becomes lower in volume unplugging and plugging in the L cable occasionally fixes it.. i've ordered a set of Hart audio cables as I wanted a shorter run...