Hello I have a WA6-SE and a Headphone Audeze LCD-3, last version 110ohms. I am using rectifier tubes USAF 596 and drivers tubes 6gl7, 6fd7 and 6rd7. My question is in which output (High or Low) is more technically correct to my LCD-3 (110ohms). 110 ohms is considered high or low impedance...

Hello I have a WA6-SE and a Headphone Audeze LCD-3, last version 110ohms. I am using rectifier tubes USAF 596 and drivers tubes 6gl7, 6fd7 and 6rd7. My question is in which output (High or Low) is more technically correct to my LCD-3 (110ohms). 110 ohms is considered high or low impedance...

Hello everyone... Recently I arrived my tube 596 ... I'm loving it! I'm trying with several tubes drivers (6EM7 / 6GL7, 6FD7, 6DR7, 6CY7 and 6EW7) ... so far, the best combinations were "596 + 6EM7 / 6GL7 ..." and "596 + 6FD7" ... With Princess Sophie, the tube 6EM7 did not seem a good tube...

I just buy a tube 596 ... you should arrive within a few days .... I have WA6SE+LCD3f...., with Sophie Princes .. 6EW7, 6FD7 ... 6EM7. One can consider that the tube 6EM7 equals 6GL7? Thank you

I have a WA6-SE and also a LCD3f. The combination is fantastic with a lot of synergy! The sound is warm is very detailed. My preferred tubes are 6FD7 and also 6GL7/6EM7 . The 6FD7 has a more relaxed sound and very pleasant, while the 6GL7/6EM7 has a more energetic sound, with detailed mids a bit...

Hi... Try This.... http://www.innerfidelity.com/content/trusted-traveling-companion-centrance-hifi-m8-portable-headphone-ampdac#lDqgZbM2A06r8h3H.97

Hello everyone! I'm a big doubt and please, I need the opinion of you. I'm in doubt between buying AMP Woo Audio WA22 or Aurilic Taurus MKII for use with LCD-3 Audeze (fazor) I always liked more amplifiers with tubes, and I was already decided to buy the WA22. However, after reading some...

Hello everyone! I'm a big doubt and please, I need the opinion of you. I'm in doubt between buying AMP Woo Audio WA22 or Aurilic Taurus MKII for use with LCD-3 Audeze (fazor) I always liked more amplifiers with tubes, and I was already decided to buy the WA22. However, after reading some...

Hello! About your question on impedance, power ... Voltage (Vrms), I believe the link below will help you!   http://www.apexhifi.com/specs.html   On the specification of the Amp you mentioned, it generates approximately 10Vrm (9,8Vrms) with 300Ohms with 320 mW of power. More than enough to...

My source is a Headroom UDAC with 2V output in Single ended.  The volume is a little loud in 1/4.  The Headphones you are going to use LCD-2 and Sennheiser HD 650.  The high gain is 16dB and gain Medium is 10dB.  Do you think the high gain, and the volume is already a bit high at 1/4 volume...

Hello!    I read the manual, I saw that there is the possibility of changing the GAIN LOW-HI to LOW-MED.  For use with LCD-2, which option do you suggest? Gain Medium or High?  Currently the concert is in the High Gain.  thank you 

I really like two players: Audirvana Plus (Not free -but, The Best Player) and that in XBMC Media Center is a reality, however, is a great music player, mainly that it works seamlessly with external DAC  Audirvana has slightly better sound quality ... even slightly.

again thank you! I'm learning a lot from you. taking advantage of their knowledge, what is your opinion on LCD -2 + meier audio CONCERT? is a good combo? I'm asking this because I'm almost buying a CONCERT.

    OK! You are right!  I do not want to listen to 120db ... what I would like is an amp that can deliver this power, not necessarily in this volume I will listen.  I believe that an AMP that can deliver this power, has much better quality at lower volumes (11 o'clock for example ...)...

I did some calculations, with the specifications of LCD-2, so I get 120 dBSPL .. I need the AMP delivered approximately 790mW (6.0 Vrms and 115mA) considering LCD-2 with 60 ohms / 90dBSPL/1mW  You think I'm right in the calculations?  I'm buying a Meier CONCERT to pair with LCD-2. I believe...

With your answer, I just test my LCD-2 with WA3.  You are right! The sound was much worse compared to LCD + fiio e17.  With low volume, it was not too bad, but .... When I plugged my Sennheiser HD 650 into WA3 ... The difference is huge!  Thank you!

For the dt 990 600 ohm I would recommend WooAudio WA3/WA6. I Have WA3 paired with a Sennheiser HD 650 - 300ohms. The sound is amazing!  The Woo WA3 is a more appropriate OTL headphone high impedance and high sensitivity  If you want to use the amp for headphones of high and low impedacia, or...

I Have a WooAudio WA3 - OTL AMP. Please, I would like to know if anyone had experience with LCD-2 + WA3.  Because the WA3 be a OTL, I have problems with low impedance headphones? Can I damage the amp?

Thank you for the quick reply!  My LCD-2 is Rev1.  I'll buy the CONCERT.  I read the specification that the maximum voltage is 13Vrms and 500mA. You think it's also a good combination with the Sennheiser HD 650 by having a dry, more neutral sound?  I ask this because I also have a HD650...

Hi ..  I have a HD 650 with AMP WOOaudio WA3 (OTL AMP).  This Combo raised the level of quality of my HD 650! With this amp the sound improved a lot, especially in the quality of BASS. The Bass became more defined and larger extent.  The Stage was amazing! I love this combo!  I also have an...

Hi ..  I recently bought a LCD-2. I'm looking for an amp that has a good parity with good cost-benefit ratio. I'm almost buying a used CONCERT Meier and I would like to know if you've tested this COMBO (2-LCD + CONCERT).  I'm new to this forum and I am Brazilian. I apologize for wrongly...