[ble0t]

That works for me if everyone else is OK with it.

 

[steinchen]

Quote:

Originally Posted by Clutz I thought it was steinchen?

I purchased the non-profit version of Eagle (limited to Eurocard-size, 2 layers and, of course, non-profit use)

Since ble0t and dsavitsk are far more involved into this project than I am the project is far better served in their hands. If there is something I can do to support you I'll gladly do, just let me know.

 

[MegaMeee]

If you 2 guys are willing then great... For a while I was wondering if there was anyone who knew how

 

[Clutz]

Quote:

Originally Posted by ble0t That works for me if everyone else is OK with it.

Two thumbs up from me.

 

[dsavitsk]

Quote:

Originally Posted by steinchen Since ble0t and dsavitsk are far more involved into this project than I am the project is far better served in their hands.

?

I think you must have me confused with someone else. I am, at best, offering comments from the sidelines, and at worst just a pain. That leaves ble0t and 00942, though, I think maybe Clutz ought to do it.

 

[SnoopyRocks]

I can do layout but there are some caveats. First, like 00940, I only have the free version of Eagle. Moreover, I'm not familiar with Eagle and I presume that it is just as difficult to pick up as other PCB suites. I'm willing to give it a shot though. As a side note, I do have a full version of Mentor Pads2005, which I do know how to use, that has no restrictions on board size or layers, not that it matters in this case.

Right now we need a floorplan for the layout. Things to consider are general signal routing and power bus placement for starters.

For the synchronization issue, my proposition is to send changes through ble0t (full version of Eagle), who can then forward updates to Clutz for web hosting. Are weekly (biweekly) updates reasonable?

 

[ble0t]

Interesting link just got posted over at diya...

http://www.cypress.com/portal/server...n_device_9.pdf

 

[steinchen]

Quote:

Originally Posted by dsavitsk ? I think you must have me confused with someone else. I am, at best, offering comments from the sidelines, and at worst just a pain. That leaves ble0t and 00942, though, I think maybe Clutz ought to do it.

sorry, you're right, I meant 00942

 

[Clutz]

Hello all

I was under the weather the past few weeks so I hadn't been doing much Head-Fi'ng (other than waiting for my K701s). I've lost track of where we were at. Is anyone else still around and kicking?

Cheers,
Clutz

 

[00940]

Bleot and I have been working quite a lot (but Bleot was gone one week). The layout of the analog section is about done, the digital section well under way, we still have to work on the supply. I've to work on the values of the output filter. We have to fix ourselves on a new spdif receiver however, since the DIR1703 is not living up to the expectations.

 

[MegaMeee]

So whats wrong with the dir1703?

 

[00940]

For the DIR1703 :
http://www.diyhifi.org/forums/viewto...=asc&start=105

 

[Clutz]

Well, then that would seem to bring us back into CS8412 territory, wouldn't it?

 

[00940]

The CS8412 is discontinued since way too long, hard to get

Even the CS8414 is getting difficult to get from common reselller. We're working with the CS8416 currently.

 

[MegaMeee]

That sounds good to me.